09-19-2011, 10:18 AM | #1 |
|
Adding an Oil Gauge
So I am adding an aftermarket oil gauge / wideband gauge into my center console using pfyc's gauge pod.
only issue is. where on the block is there a connection that i can put the sending unit for the oil gauge? I know on old gen-1 sbc blocks, there were many connections, but on the lsx376.. i'm not sure at all. any help would be great. also if you have a picture. that would be even better. |
09-19-2011, 10:31 AM | #2 |
|
okay i may have answered my own question with this document...
Last edited by Nvincent4708; 10-24-2019 at 02:22 PM. |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY: LS3 Camshaft Install (a lot of pictures, may take a moment to load) | robertway | Camaro DIY & HOW-TO instructions & discussions | 313 | 12-16-2023 06:53 PM |
DIY: Camaro Oil Change | adub4185 | Camaro DIY & HOW-TO instructions & discussions | 180 | 04-23-2014 06:11 PM |
synthetic motor oil? | bigd1276 | Mechanical Maintenance: Break-in / Oil & Fluids / Servicing | 71 | 01-29-2009 12:28 PM |
Major U.S. oil source is tapped | KILLER74Z28 | Off-topic Discussions | 32 | 10-30-2007 09:47 AM |