help with eagle eyes halos - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

abelsspeedy · 07-22-2011, 07:30 PM

Since i installed the halos i have been having problems with the passanger halo. when i use the remote start it doesnt stop flikering. it stops after i put the key foward and rev the engine for a little bit. people tell me that its because the halo doesnt have enough power. I know i used a rellay harness for the HID's for the same problem. the question is if i can buy and use the same rellay harness used for hid's for the halos? the rellay has a 40 amp and 12 volt rellay.

abelsspeedy · 08-01-2011, 02:21 PM

well i installed the rellay already. the halo flicker a lot less. now the question is were is the best place to attach the ground cable to? somebody told me that now i needed more ground (negative).

The Stig · 08-01-2011, 02:31 PM

you can't have "more" ground. Your circuit is either grounded or it's not. There is a ground stud in the engine bay. It is on the driver's side, a little silver pole coming out from the inside of the fender. Right at the top near where the hood sits.

abelsspeedy · 08-01-2011, 03:56 PM

Quote:

Originally Posted by stieger

you can't have "more" ground. Your circuit is either grounded or it's not. There is a ground stud in the engine bay. It is on the driver's side, a little silver pole coming out from the inside of the fender. Right at the top near where the hood sits.

Well i guess what i should have said was better ground but thanks for the help and will try that this after noon.

H3LL1ON · 08-02-2011, 02:10 PM

Where did you hook up the halos to?

07-22-2011, 07:30 PM	#1
abelsspeedy Drives: 10 2SS VR, 08 Escalade Join Date: Jun 2011 Location: South Texas Posts: 38 View My Garage	help with eagle eyes halos Since i installed the halos i have been having problems with the passanger halo. when i use the remote start it doesnt stop flikering. it stops after i put the key foward and rev the engine for a little bit. people tell me that its because the halo doesnt have enough power. I know i used a rellay harness for the HID's for the same problem. the question is if i can buy and use the same rellay harness used for hid's for the halos? the rellay has a 40 amp and 12 volt rellay.

08-01-2011, 02:31 PM	#3
The Stig knows 2 facts about ducks Drives: ...and they're both wrong Join Date: Aug 2009 Location: The HMS Invincible Posts: 25,072 View My Garage	you can't have "more" ground. Your circuit is either grounded or it's not. There is a ground stud in the engine bay. It is on the driver's side, a little silver pole coming out from the inside of the fender. Right at the top near where the hood sits. __________________

08-02-2011, 02:10 PM	#5
H3LL1ON H3LL1ON Drives: 2010 1LT Camaro Synergy Green Join Date: Jul 2010 Location: Ontario Posts: 222	Where did you hook up the halos to? __________________ It's Green, really Green! C5

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
EAGLE EYES Passenger HALO Problems? Please speak up here	vdevine	Cosmetics and Lighting Modification Discussions	37	05-30-2017 07:40 PM
DIY: Halo as DRL on Eagle Eyes	MagnumForceGB	Camaro DIY & HOW-TO instructions & discussions	15	03-25-2014 05:54 PM
Help with eagle eyes	gjarzabek009	Cosmetics and Lighting Modification Discussions	6	07-03-2011 06:04 PM
Eagle eyes with heratige grille?? Can you do it and look right?	Lightningquick	Cosmetics and Lighting Modification Discussions	4	04-10-2011 05:50 PM
Group Buy!!! LED Headlight and Tail Light HALOS, Only $99 Each!!!	Wes@Flashtech	Exterior Parts & Accessories	51	09-27-2010 08:19 PM

08-01-2011, 02:21 PM	#2
abelsspeedy Drives: 10 2SS VR, 08 Escalade Join Date: Jun 2011 Location: South Texas Posts: 38 View My Garage	well i installed the rellay already. the halo flicker a lot less. now the question is were is the best place to attach the ground cable to? somebody told me that now i needed more ground (negative).