05-17-2013, 02:44 PM | #15 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
Got mine, thanks, now I need to figure out just where I'll place them, probably the small windows like most have done. They really look good!
|
05-19-2013, 03:20 PM | #16 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
Installed the red decal on the engine cover and the black/drivers side small window. Went to try to do the passenger side window and the decal REFUSED to peel off the backing paper. Parts would and some parts wouldn't and then the lines started curling and sticking to its self. At that point it was done, it just became to mangled, so its one only on the drivers side. Better than none I guess.
|
05-19-2013, 03:39 PM | #17 |
NewDivide
Drives: SW '13 1SS/RS & '12 Honda CRV Join Date: Jan 2011
Location: South East, Mass
Posts: 921
|
I found that going over the decal a few times w/ the side of a credit card before peeling the back off helped a lot.
__________________
|
05-19-2013, 05:51 PM | #18 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
Wish I just could get out from under that very dark cloud that seems to be following me everywhere. As they sh*t happens.
|
05-19-2013, 07:31 PM | #19 | |
The Mark of Excellence
Drives: 2010 ABM 1SS RS LS3 Join Date: Jan 2009
Location: Smallest State in the Union
Posts: 8,690
|
Quote:
__________________
BMR, CAI, DynoMax, Elite Eng., Hurst, Jannetty, Clear Image Headers & Hi Flow cats, Jet Hot, LSR, TSW, VMax, Vredestein |
|
05-19-2013, 07:40 PM | #20 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
|
05-19-2013, 07:42 PM | #21 |
The Mark of Excellence
Drives: 2010 ABM 1SS RS LS3 Join Date: Jan 2009
Location: Smallest State in the Union
Posts: 8,690
|
__________________
BMR, CAI, DynoMax, Elite Eng., Hurst, Jannetty, Clear Image Headers & Hi Flow cats, Jet Hot, LSR, TSW, VMax, Vredestein |
05-19-2013, 10:30 PM | #22 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
Passenger side w/decal driving towards the front of car. So I'm guessing that's the right side. The good one is on the drivers side.
Passenger side decal just became to mangled and distorted. |
05-20-2013, 06:56 AM | #23 | |
The Mark of Excellence
Drives: 2010 ABM 1SS RS LS3 Join Date: Jan 2009
Location: Smallest State in the Union
Posts: 8,690
|
Quote:
__________________
BMR, CAI, DynoMax, Elite Eng., Hurst, Jannetty, Clear Image Headers & Hi Flow cats, Jet Hot, LSR, TSW, VMax, Vredestein |
|
05-20-2013, 08:07 AM | #24 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
|
05-20-2013, 08:14 AM | #25 |
It's in black & white
Drives: 2012 ZL1 Summit White #1366 Join Date: Jul 2012
Location: Vernon CT
Posts: 1,855
|
What side was in the sun when you installed them?
I would think low heat or cold glass may be difficult ... or even to much heat...
__________________
FAIRNOT ZL1
|
05-28-2013, 06:41 AM | #26 |
The Mark of Excellence
Drives: 2010 ABM 1SS RS LS3 Join Date: Jan 2009
Location: Smallest State in the Union
Posts: 8,690
|
Still have decals available, check the first post for colors or pm me.
__________________
BMR, CAI, DynoMax, Elite Eng., Hurst, Jannetty, Clear Image Headers & Hi Flow cats, Jet Hot, LSR, TSW, VMax, Vredestein |
05-28-2013, 09:25 AM | #27 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
The replacement decal for the passenger side window went on without a hitch. Not sure what the deal was with that first one, but it just refused to peel off the backing paper. They look great! Subtle and discrete, you don't notice them until you're up close, fits right in with the Dark and Menacing stealth stance.
|
05-31-2013, 02:44 PM | #28 |
Drives: 2013 Ashen Gray M6 ZL1 Join Date: Sep 2012
Location: South Eastern, Mass
Posts: 2,615
|
Left and right, look'n good!
|
|
|