06-08-2013, 05:04 PM | #1 |
V8 lounge member #5
Drives: 12 2SS Synergy Camaro, 05 PontiacG6 Join Date: Dec 2011
Location: Ohio
Posts: 1,301
|
What did you use, S/c install
Re-installing my vortech ysi supercharger bracket. I know the instructions don't call for anything but did YOU use any locktite or anti seize on the bracket bolts?
|
06-08-2013, 06:26 PM | #2 |
Drives: 2009 ZR1 Join Date: May 2010
Location: KCMO
Posts: 3,205
|
I did not use locktite except where the instructions said to (crank pulley, blower pulley and anywhere else I forgot to mention). I did use antiseize on the bolts that go into the head.
The rest of them I just tightened down. It won't hurt to use blue (medium strength) anywhere you see fit. |
06-08-2013, 06:50 PM | #3 |
V8 lounge member #5
Drives: 12 2SS Synergy Camaro, 05 PontiacG6 Join Date: Dec 2011
Location: Ohio
Posts: 1,301
|
I was just surprised that it didn't say to on the bracket bolts, specially when you're mixing metals like that.
|
06-08-2013, 09:12 PM | #4 |
Make your peace with God!
Drives: 2011 Camaro SS/RS M6 Convertible Join Date: Dec 2011
Location: Dirty Jersey
Posts: 1,595
|
I didn't do the ORIGINAL install on my setup, but recently I had to take the blower off which means I had to take all the bracketry off. There was no lock-tite on those bolts and I didn't use any when reinstalling. I just tightened down and went about a 1/4 turn after that.
__________________
ECS base supercharger (NOVI 1500SL), ECS AlKY control kit, 92mm TB, ARH 1 7/8" LT's non-catted, Borla 3" exhaust, ID850 injectors, Squash fuel system, ECS Big Blower Cam, MGW short throw shifter, DSS 1000hp axles, LGW differential cover, billet caps, Tech AFX heater hoses, Pedders differential bushings, Eaton TrueTrac differential, PRC dual valve springs, Katech C5R timing chain, ATI balancer, Meilings oil pump, Pfadt Trailing Arms, Pfadt Tie Rods, Pfadt Sway Bars, Pfadt End Links, DSS Aluminum Driveshaft
811RWHP/719RWTQ UNDER MAJOR OVERHAUL!! |
06-08-2013, 10:07 PM | #5 |
Drives: 2011 Inferno Orange SS Convertible Join Date: Apr 2012
Location: Tyrone, PA
Posts: 640
|
I don't like thread lockers. I use them almost never. Proper torque.
__________________
2011 SS IOM Vert. ECS Vortech 13+ psi, Water/Meth, ID850’s, ZL1 pump with MSD Voltage Booster, 2800 stall, LT headers, Drag radials, Drag alignment, Cradle Bushings. A million other supporting mods. Tuned by Ted.
|
|
|
|
|