Will the Borla S-Type part # 11775 Axle-back fit a 2014 Camaro V6? - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

Lucky Red · 05-18-2014, 03:06 AM

I want to purchase an exhaust and I saw a very cheap Borla S-Type part # 11775 that used to be on a Camaro SS, will it fit my V6?

Apex Motorsports · 05-18-2014, 12:09 PM

That is an axle back for the SS. It could be made to work but it would not be a basic bolt on install.

Ventmaster · 05-19-2014, 08:47 PM

The pipes on the Borla 11775 are made to slip over the SS's 2.5" pipes close to the back axle.

Your V6 has 2.25" pipes at that point. You could easily have them welded instead of clamped (would cost a little- but if it's a really good price, could be worth it... these things sell for like 600 bucks new!), or buy some reducer adapters and an extra set of clamps and do it yourself.

05-18-2014, 03:06 AM	#1
Lucky Red Drives: 2014 Camaro Join Date: May 2014 Location: San Diego Posts: 5 View My Garage	Will the Borla S-Type part # 11775 Axle-back fit a 2014 Camaro V6? I want to purchase an exhaust and I saw a very cheap Borla S-Type part # 11775 that used to be on a Camaro SS, will it fit my V6?

05-18-2014, 12:09 PM	#2
Apex Motorsports Drives: 2000 Camaro SS Join Date: Feb 2010 Location: Louisville, Ky. Posts: 25,179	That is an axle back for the SS. It could be made to work but it would not be a basic bolt on install.

05-19-2014, 08:47 PM	#3
Ventmaster Drives: 2017 1SS 6spd Join Date: Jan 2011 Location: Utah Posts: 2,869	The pipes on the Borla 11775 are made to slip over the SS's 2.5" pipes close to the back axle. Your V6 has 2.25" pipes at that point. You could easily have them welded instead of clamped (would cost a little- but if it's a really good price, could be worth it... these things sell for like 600 bucks new!), or buy some reducer adapters and an extra set of clamps and do it yourself.