05-12-2013, 05:26 PM | #1 |
Drives: CamaroRS1991WhiteT-Tops Join Date: May 2013
Location: GothamCity
Posts: 2
|
1991CamaroRSWheelBearingIssue
We have a 1991 Project Camaro that we have changed the wheel bearing and started to drive the car while upon 5 minutes of driving the car it started to rattle again on the left side which is the side we just changed the wheel bearing. Later we took the wheel/break/rotor off and looking on the part that is the attached part looked like it had a small cylinder holder for the wheel rotor.....????? we also didn't change the bearings seal because the old ones looked fine.
Please help if possible thank you for taking the time to read this! Have a great day!!!! Hopefully we did not |
05-12-2013, 07:06 PM | #2 |
Drives: CamaroRS1991WhiteT-Tops Join Date: May 2013
Location: GothamCity
Posts: 2
|
It was a Fail on our part we forgot to put something back on.......... LOL
|
09-05-2013, 01:44 AM | #3 |
Olson Kustom Works
Drives: 91 Camaro, LS3, TVS2300, TR6060 Join Date: Dec 2011
Location: Anaheim, CA
Posts: 134
|
cotter pin?
|
|
|
|
|