02-04-2011, 03:20 PM | #1 | |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
98 Z28 built LS3 427ci
I'm listing the Camaro for sale. If I don’t get the price I want, then I wont sell. I have the title in hand, ready to sell. Also, clear title.
Those that know me and have seen my car know that I take exceptional care of it. This isn’t some quickly thrown together project either… only the best parts have been used and the car runs amazing. Its pretty much a full track car ready to run 10’s, also has VERY good street manners. Also full interior, heat, and AC all work. Power everything. Car is tuned conservatively for maximum driveability, and put down 543 rwhp and 505 rwtq on the dyno. *NOTE: I will smog for buyer. After that its the buyer's responsibility to find someone to get it smogged again in 2 years.* I have over $25k into actual mods on the car, not including the cost of the car. I am in no hurry to sell, so if I don’t get the price I want I will keep it. Pretty firm on the price: $15,500 1998 Camaro Z28 Motor: -Factory new LS3 block -427ci, 12:1 CR, bored/stroked/balanced/blueprinted -Forged Compstar 4.1" crank -Forged Compstar rods -Custom Wiseco forged pistons -ARP studs -TSP ported L92 heads -L76 intake manifold (paint matched to car) -TSP 251/259 on 111 lsa .661 lift -Kooks 1 7/8 LTs -Nick Williams 90mm throttle body -42# injectors -Walbro 255lph fuel pump with custom access panel -3" true duals with Dr. Gas X-pipe and magnaflow mufflers -Dual DMH low-profile e-cutouts -Fast Toys 85mm lid -SLP CIA duct -ZO6 MAF -Optima Red Top -Abear Motorsports polished valve covers (coil packs sit inside) Drivetrain: -D&D built T56 -Spec 3 clutch and billet flywheel -WS6 store short stick -Hurst classic white 6-speed shift ball -3.42 gears Suspension/Braking -BMR tubular K-member -BMR upper and lower tubular A-arms (adjustable) -Strano revalved Bilstiens -BMR 1" springs -BMR boxed subrames -BMR adj torque arm -BMR adj LCAs -BMR Xtreme STB (powdercoated black) -BMR adj PHB -Trac Tek relocation brackets -Wolfe 6-point roll bar with door swingouts. -Stroud 5-point safety harnesses -Powerstop crossdrilled rotors -Hawk Ceramic brake pads -Earl’s Stainless Steel brake lines -ARP 3.25” lengthened wheel studs for track use (all 4 corners) Interior -Brand new carpet from Stock Interiors -Raamat sound deadening throughout entire car -Retained stock seatbelts with racing harnesses -Rear seat delete -Pioneer DEH-P6050 -Alpine 6 ½” speakers in middle panels -Interior trim pieces professionally sanded and painted to match factory ext -Custom TA seats, repadded, genuine leather, real suede inserts, heaters, headrest embroidery -Brand new GM seatbelts -Emblem Pros ashtray switch plate for cutouts and line lock Exterior -SLP Ultra Z Ram Air hood -RK Sport smooth grill with mesh behind -Halo headlights (chrome) -Brand new clear corners -Custom stainless 427 badges (in Z28 font) by Emblem Pros -Stainless CAMARO inserts on rear panel by Emblem Pros -Chrome SS 10spokes -rear 10spokes custom widened by Weldcraft to 17x11 -custom spacers for unique offset -275’s up front, 315’s out back -Paint is swirl and scratch free Mileage: -Body 160k -rear 80k -motor 4k -trans 2k Pics additional interior pics *disregard the little bit of dirtiness...will all be perfectly clean for buyer. I am a professional detailer afterall* disregard panel gaps. The clips aren't installed right now (sitting in rear cup holders) and will be put back in this week.
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig Last edited by gofast908z; 03-21-2011 at 06:32 PM. |
|
02-04-2011, 05:02 PM | #2 |
Account Suspended
Drives: 2012 Camaro RS, RX supercharged Join Date: Dec 2009
Location: Bradenton, FL
Posts: 6,063
|
Beautiful car! Well worth the price, could not come close to duplicating it for that.
|
02-06-2011, 10:42 AM | #3 |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
Thanks!
TTT
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig |
02-08-2011, 02:34 AM | #4 |
|
where in cali?
|
02-08-2011, 03:02 AM | #5 |
Don't Like it? Suggit.
|
Wow. Had this car only been up for sale a few years back..........
__________________
"Tops off, tach up baby- loud and proud!" A Camaro lover from day one- 1996 3.8 V6 Camaro, to 1996 5.7 LT1 Camaro Z28, to the sold 2002 5.7 LS1 Camaro SS, and NOW, a [I]6.2 L99 VR 2SS/RS: XS Power stainless full exhaust, Airaid CAI, BMR drop springs and sways, custom tune by Cal Speed- 411rwhp |
02-08-2011, 10:13 AM | #6 |
Drives: '16 Z06 M7 Join Date: Jul 2009
Location: Detroit Metro
Posts: 208
|
I have looked at your posts the last few months, and its hard to believe nobody has bought that car! I figured it would have gone in a heartbeat on LS1tech. I wish I was in Cali, and didn't need a snow ready driver... I will be moving to Arizona in about a year. If you still have it then I will def buy it. GLWS until then!
__________________
2016 Corvette Z06 M7: Halltech Intake, Corsa X-Pipe, MGW Shifter
|
02-08-2011, 10:18 AM | #7 |
|
Awesome Camaro, wish we lived closer so I could come check it out.
__________________
Jannetty Racing JRE Street Package
|
02-09-2011, 02:52 PM | #8 |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
Its located in Antioch, CA.
I don't know why it hasn't sold yet... Price is fair and the performance is extreme. Maybe its just too much of a niche?
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig |
02-09-2011, 11:47 PM | #9 |
|
I am not sure either. It is a great car I would love to get it but have to talk it over. I am interested but unsure about my finances.
|
02-10-2011, 05:10 AM | #10 |
SoCal HT5 (COTW:12/26/11)
Drives: 2011 Inferno Orange 2SS Join Date: Jul 2010
Location: Diego Garcia, BIOT
Posts: 399
|
Wow NICE ride bro, this is a steal, buy it throw a Supercharger on it, and your set!! Wish i had the cash id pick it up, using all mine to build my 2011-IOSS, But best of luck with the sale!
|
02-13-2011, 10:05 PM | #11 |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
Thanks!
TTT
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig |
03-06-2011, 06:24 PM | #12 |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
back up top
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig |
03-06-2011, 06:33 PM | #13 |
Drives: 2010 dodge challenger!! 2010 2ss/rs Join Date: Dec 2009
Location: Texas
Posts: 86
|
Oh my gosh that is an amazing beast!
|
03-21-2011, 06:33 PM | #14 |
Drives: Camaro Join Date: Apr 2009
Location: California
Posts: 400
|
Thank you!
Additional interior pics added.
__________________
Jeff
2008 Z06 - Heads/cam/intake/exhaust/tune 2005 Sierra STL ext cab -5.3L, Daily/Detail Rig |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shno's House of Z | Number 3 | Camaro Z/28 Forum - Z/28 Specific Topics | 17976 | 12-27-2021 12:07 PM |
Unofficial 1/4 Mile (V8) 2010+ Camaro Fast List | Merc | Dragstrip and Launch Techniques Discussion | 250 | 04-01-2014 10:40 AM |
Think about this and the Z28 5th gen | 13F20 | Camaro ZL1 Forum - ZL1 Specific Topics | 41 | 09-04-2010 12:59 AM |
Check your Order here | bvonscott | Camaro Price | Ordering | Tracking | Dealers Discussions | 665 | 06-29-2009 01:00 PM |
Can a Superchagered Z28 have a lumpey CAM, and sound like a NA heads and cammed LS3 | D-Unit | Forced Induction - V8 | 12 | 07-29-2008 03:34 PM |