04-10-2014, 08:49 AM | #1 |
Dash Seperated
So I noticed today that my dash and silver around the gauges behind the steering wheel has seperated. I took it to my dealer and they pulled the silver off, and I have one of the small retainers is like chipped at the top and it's not allowing the silver to sit flush anymore. Only way to get it fixed is to replace the whole dash. And that creates the chance of getting a rattle in the dash. Have any of you had it replaced, if so does it rattle, if not what do you think I should do.
__________________
2013 Summit White ZL1
|
|
04-10-2014, 09:18 AM | #2 |
Drives: 2013 Triple Black ZL1 Vert M6 ECF Join Date: Mar 2011
Location: Trenton, Michigan
Posts: 7,047
|
get it replaced as the dealer suggested. If it rattles, it's up to them to fix that as well.
|
04-10-2014, 10:13 AM | #3 |
Coupe Newbie
Drives: 2017 ZL1, 2021 Corvette Convertible Join Date: Jul 2011
Location: Columbus, Ohio
Posts: 3,281
|
I have the same issue with my gauges bezel.
When you reinstall the bezel, you have to come in at an angle from above the gauges. I managed to make the separation a little smaller doing this. The separation really bugged me at first, but I've since learned to accept it. I considered using some silicone adhesive to glue it down to the dash. I still might try this now that the weather is starting to warm up. I'm afraid replacing the dash may be one of those cases where the cure is worse than the disease.
__________________
Last edited by hawk02; 04-10-2014 at 10:40 AM. |
04-10-2014, 10:21 AM | #4 |
COTW 12/3/12
Drives: 2012 Ashen Gray ZL1 Join Date: Aug 2011
Location: Glen Carbon, IL
Posts: 3,279
|
Yeah, once that piece is removed it will NEVER sit flush again! Mine is nowhere near as bad as the ones pictured above, but there is a small gap at that same corner on almost all I have seen that have been removed.
I actually hardly ever notice mine anymore and just the other day looked to see if it was still there. I guess it just looks normal to me now. |
04-10-2014, 10:56 AM | #5 | |
Drives: ZL1 Convertible Join Date: Aug 2012
Location: Chicago, IL
Posts: 484
|
Quote:
Unless I were to get my convertible at <50k new . . . then I'd just assume that my 'stolen' car would eventually get costs recouped at the dealer. |
|
04-10-2014, 11:30 AM | #6 |
Drives: 2016 CAMARO 1SS Hyper Blue Met. Join Date: Jul 2009
Location: Tucson, Arizona
Posts: 1,593
|
I had the dash replaced in my 2010 SS just over 2 years ago due to the Air Bag cracks and so far, no rattles or squeaks. Really depends on how good the technician is that is doing the replacement.
__________________
proud member "club elite" # 89
|
04-10-2014, 11:40 AM | #7 |
Let's go Rangers!
|
Common issue, unfortunatly (like you said) the only was to fix this is replace the dash. I've decided to just live with it rather then have my whole dash replaced.
|
04-10-2014, 01:54 PM | #8 |
Drives: 2013 ZL1 Vert Auto IOM Join Date: May 2012
Location: Alberta
Posts: 389
|
Same issue with mine, noticed it with the original bezel, I replaced it with a painted one and it was much worse, athough I found a way to reseat it and end up with the same gap as the original bezel, I am just going to live with it.
|
04-10-2014, 02:56 PM | #9 |
2018 Garnet Red ZL1 conve
Drives: 2013 & 2018 ZL1 vert Join Date: May 2009
Location: Des Moines, IA
Posts: 1,471
|
I've got the same problem. I think I will be using some silicone when the weather gets nice out. It's one of those little things that really bothers me. To much OCD!!
__________________
Build Thread: 2018 ZL1 Vert Purchased (Overpar73)
|
04-10-2014, 03:27 PM | #10 |
Drives: 2014 ZL1 White Convertible Join Date: Aug 2013
Location: St Pete Fl
Posts: 682
|
Just went out and looked at mine. There is about a 2mm gap in some places going around the gauges, but I feel it is well within the accept limitations. I would never have thought to look had this issue not been posted.
|
04-10-2014, 03:35 PM | #11 |
Drives: 2013 Triple Black ZL1 Vert M6 ECF Join Date: Mar 2011
Location: Trenton, Michigan
Posts: 7,047
|
Put a dab of silicone in the gap, use a piece of tape to hold it together until the silicone cures, and you're done.
|
04-10-2014, 05:49 PM | #12 |
Gonna get it hydro dipped before I silicone it. And does the strip across the dash on the left side just on there with double sides tape? And the passenger side? Might as well get it all dipped at the same time.
__________________
2013 Summit White ZL1
|
|
|
|
|
|