Need Some Help - Bubba Worked On My Camaro - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

ratfinkharley · 04-28-2014, 08:45 PM

I was test fitting my Apex Catch Can and discovered that there was little to no clearance on the inlet side and the ECU. The mounting bracket is not flush with the inner support and a zip tie was used to secure the ECU to the bracket. The ECU was securely clipped in.

Taking it apart, there are two tabs that don't have a corresponding holes, causing the bracket to stick out. It clips in, but not flush.

I looked up the part number 92241771 and it is correct. In the last pic, you can see where the tabs have worn the paint above the mounting holes.

Any thoughts?

[IMG]

[/IMG]

[IMG]

[/IMG]

[IMG]

[/IMG]

thkfast · 04-30-2014, 04:16 AM

....wait for it...Chase?

04-28-2014, 08:45 PM	#1
ratfinkharley Drives: 15 JKU, 00 S10, 73 Vette, 12 JK Join Date: Jan 2014 Location: garage Posts: 370	Need Some Help - Bubba Worked On My Camaro I was test fitting my Apex Catch Can and discovered that there was little to no clearance on the inlet side and the ECU. The mounting bracket is not flush with the inner support and a zip tie was used to secure the ECU to the bracket. The ECU was securely clipped in. Taking it apart, there are two tabs that don't have a corresponding holes, causing the bracket to stick out. It clips in, but not flush. I looked up the part number 92241771 and it is correct. In the last pic, you can see where the tabs have worn the paint above the mounting holes. Any thoughts? [IMG][/IMG] [IMG][/IMG] [IMG][/IMG] [IMG][/IMG] __________________ RotoFab CAI - VMaxx Ported TB - Apex Catch Can - CFD Shifter - Choppers Inc Loaded Dice Shift Knob Last edited by ratfinkharley; 04-28-2014 at 09:37 PM.

04-30-2014, 04:16 AM	#2
thkfast Drives: '14 Red 2SS/RS/LS3 Join Date: Dec 2013 Location: Cedar Rapids, IA Posts: 692	....wait for it...Chase? __________________ 2014 Red Hot 2SS/RS/M6/NPP/Shifter/Nav/Roof/SilverRallyStripes/Airaid intake/GM StrutTowerBrace/50%-35%tint