02-22-2015, 07:28 PM | #1 |
Account Suspended
Drives: Camaro 2SS RS L99 Blk with IOM pkg. Join Date: Sep 2014
Location: Detroit
Posts: 143
|
Flowmaster Outlaw 817504 Where to CUT???
I have seen the installation file from Flowmaster; they recommend cutting 9.5" from the end of hangers in the directions. However, on their website they have an install peformed and the Flowmaster Tech recommends cutting at 9" from the end of hangers?
Question: Anyone know the "SPECIFIC MEASURMENT" from the hangers that will set your exhaust tips to the "ORIGINAL FACTORY POSITION"? This will be helpful in determining where to cut in the event that you want your exhaust tips to extend a little further, or vise-versa? If we know what measurement will yeild the factory location, we can simply subtract an inch or two to get the tips where we "WANT THEM"? It would be terrible to cut it too short!!! |
02-22-2015, 08:35 PM | #2 |
Drives: 2010 IOM 2SS/RS Join Date: Oct 2008
Location: NJ
Posts: 633
|
I had the same confusion when installing mine - 2 years ago so my memory is fuzzy. What I did was cut less (maybe 8", I don't remember), test-fit, and then cut again until I got the tips to the desired place.
Once you cut too much you can never go back. Good luck. |
|
|
|
|