Plasti-dip =)

[Hayden]

I'm considering doing my rear blackout with plasti dip. I've used plasti dip many times and understand techniques to having perfect lines and it would be a whole lot cheaper then the vinyl blackout and may also cover the areas better!

[Jerry7297]

Originally Posted by Camaroblk

thanks for the info , so u took the tape while its still wet ?

also can u take a close pic to the line ? if u dont mind ?

thanks

Yes if you are painting a large area like this just start taking the tape off of the side you started at when you get done with your coat. Unless you really over do your coat it wont run. Here are a couple more pics the pin stripe is vinyl.

[tinnint1]

Originally Posted by Jerry7297

Actually now not seen in this pic I added a red pinstripe and the edge is perfect.

What did you use to pin stripe it with? You have pictures doing that by any chance? Thanks!

[StormtrooperJun]

Originally Posted by nyrfan

It is not at all necessary to tape of any part of the emblem. Once the spray is dry you can peel of the part you want (inside or outside) with no issues. The gap makes the break perfect.

[Forte]

So for a large area like the blackout between the lights, do you spray then remove tape when wet, then let it dry, then tape again and do the same thing??

[Jerry7297]

Originally Posted by Forte

So for a large area like the blackout between the lights, do you spray then remove tape when wet, then let it dry, then tape again and do the same thing??

There may be a better way but I could not think of one. That is what I did.

----------------------------------------------------------------------------------
What did you use to pin stripe it with? You have pictures doing that by any chance? Thanks!

- No pics of me installing it but here is a pic of what i bought. It was like 2.99 at autozone. -

[SSICKO]

looks cool