03-25-2012, 08:43 PM | #1 |
Service StabiliTrak Message, please help!!
Hello everyone,
So here is my issue: I haven't driven my HPE 650 camaro for about a week (was comfortable in my garage) and I went to move it today so I could preform some brake work on my DD. When I started my camaro I received the Service StailiTrak message and I am not sure why, I am also scared to drive the car out as it runs horrible and feels like it is on 4 rather than 8 cylinders until I have more info. If anyone has any information on this subject, please let me know! Thanks |
|
03-25-2012, 08:45 PM | #2 |
Drives: SGM, 2011 2SS/RS, L99 Join Date: Oct 2011
Location: Wildcat Country
Posts: 593
|
Check your spark plugs. Similar thing happened to me.
__________________
K&N air intake, Solo w/Jpipes axleback, SP 1 7/8 LT headers
|
03-25-2012, 09:41 PM | #3 |
so far 4 plugs down and they all look great, now I have to move to the almost impossible to remove 0 room passenger side
|
|
03-25-2012, 09:46 PM | #4 |
Drives: SGM, 2011 2SS/RS, L99 Join Date: Oct 2011
Location: Wildcat Country
Posts: 593
|
Also when I had asked this someone suggested looking under the car where some of the wires hang down. They can get to close to your headers and burn which almost happened to me but I caught it before it melted the wires and tied it off with a zip-tie.
__________________
K&N air intake, Solo w/Jpipes axleback, SP 1 7/8 LT headers
|
03-25-2012, 10:17 PM | #5 |
I have the mesh case around all of my plug wires between the headers and I dont see any burning marks on them, but i did notice some oil on the further threads away from the spark end, altho it doesn't look like the oil made it very far down on any of the 3
|
|
03-25-2012, 10:38 PM | #6 |
Drives: Sold: 2011 2SS/RS Join Date: Dec 2010
Location: United States
Posts: 1,896
|
If the message flashes for just a brief moment when starting the car and doesn't set a code or constant warning, this is a known issue on 2010-2011 Camaros. If you turn the car to "on" and let the gauges sweep and chime extinguish, and then start the car, you shouldn't get the message. If you do, then there's probably a problem.
|
03-25-2012, 10:41 PM | #7 |
car starts, message stays, runs awful, so far driver side 4 plugs look good, now i need to take some time to check the 4 on the passenger side unless anyone has some other tips or tips on how to best remove these boxed in plugs?
|
|
03-25-2012, 10:51 PM | #8 | |
Drives: 2020 Summit White LT1 M6 Join Date: Sep 2011
Location: Dallas, TX
Posts: 1,033
|
Quote:
__________________
2020 Summit White LT1 M6
|
|
03-25-2012, 11:10 PM | #9 | |
Drives: Sold: 2011 2SS/RS Join Date: Dec 2010
Location: United States
Posts: 1,896
|
Quote:
|
|
03-26-2012, 08:40 AM | #10 |
Drives: 2012 camaro Join Date: Feb 2012
Location: central VA
Posts: 3,196
|
|
03-26-2012, 08:47 AM | #11 |
Drives: 2011RedJewel, FI Join Date: Dec 2011
Location: San Antonio,TX
Posts: 816
|
I'd give Hennessey a call maybe they've seen this before.
|
03-26-2012, 05:26 PM | #12 |
Drives: SGM, 2011 2SS/RS, L99 Join Date: Oct 2011
Location: Wildcat Country
Posts: 593
|
I had a loose spark plug I didnt plug in all the way after my header install and it ran like shit. Missing a jerking every time it changed gears. All the service stabilitrac lights were on. I found the loose plug and plugged it in and it ran smooth, no lights.
__________________
K&N air intake, Solo w/Jpipes axleback, SP 1 7/8 LT headers
|
03-26-2012, 08:26 PM | #13 |
okay so an update after i limped to get the codes read at a near by auto shop:
Codes Thrown: P0300 P0202 P0204 P0206 P0208 P0300: This is what I already concluded as it tells me I have a cylinder misfiring P0202-8: These codes each tell me I have a bad fuel injector for cylinder 2, 4, 6 and 8. I think it has to be another problem as it is way to much a co-wink-e-dink that every fuel injector on one side of the engine goes bad after no signs and a week in the garage after a standard daily outting? I have contacted Hennessey and am waiting for their head tuner to call me back, but in the mean time I would love any additional input to try and solve this issue ASAP |
|
10-31-2014, 12:44 PM | #14 |
Drives: 2010 Camaro 2SS Join Date: Jun 2010
Location: Navarre, FL
Posts: 745
|
Update?
|
|
|
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What is the real Service Interval | Verio | Mechanical Maintenance: Break-in / Oil & Fluids / Servicing | 14 | 12-27-2013 11:44 AM |
tpms service message | pwrmanpaul66 | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 9 | 05-06-2012 09:20 AM |
Onstar....a spy???? please comment | dieseldave24v | General Automotive + Other Cars Discussion | 138 | 02-23-2012 01:12 PM |
Laws Protecting Consumers for Aftermarket Parts | strauchpete | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 9 | 01-17-2010 08:31 AM |
Service Stabilitrak? (Launch Control) | tommygun6644 | 5th Gen Camaro SS LS LT General Discussions | 7 | 12-22-2009 11:11 AM |