Do I get these parts?

[RickyTheStorm]

So I am putting a MAST Motorsports Stage 2 cam in, ARH Long Tube Headers, Flowmaster Exhaust, Torque converter, Vararam CAI.

I was just wondering if these parts should be put on as well?:

Toe Rods
Subframe Connectors
Drive Shaft Tunnel Brace


I will already have the front driveshaft loop and trailing arms.

[d69chris]

You forgot trailing arms, diff. bushings, sky hooks, dual mode hyperbolees, and mass spec photon torpeedos!

Just kidding, trailing arms are an easy add to complement the toes. What kind of RWHP are you expecting and are you going to push the car very often?

There are a lot of threads in this regard, you just need to look and read. My car has a vortech and is pushing 460-480 RWHP. I have the trailing arms, toes, subs, & tunnel and like going to the drags every six weeks. We probably do somemore stuff to tighten up the rearend and imrpove the handling of the car.

http://www.camaro5.com/forums/showthread.php?t=62246

[RickyTheStorm]

Trailing arms are on the list. I will go ahead and put the toes and subframe connectors and the tunnel brace on too.

Not exactly sure what RWHP I am expecting, hopefully close to 500

[g-townmach]

Your car should be HAULING ASS after your mods you're gunna do. If I were you, I would look at investing in some nitto DR's and possibly even stronger half shafts. Post info about the stage 2 cam from Mast when you get it in. I've got love for those guys cuz they're all graduates from Texas A&M.

[RickyTheStorm]

Originally Posted by g-townmach

Your car should be HAULING ASS after your mods you're gunna do. If I were you, I would look at investing in some nitto DR's and possibly even stronger half shafts. Post info about the stage 2 cam from Mast when you get it in. I've got love for those guys cuz they're all graduates from Texas A&M.

I hope it does haul some ass (don't want it to run faster than 11.5 but I really don't think it will run that fast with the mods I'm doing). Already have the Nitto NT555Rs picked out As far as stronger half shafts, any thoughts on best site to order them from?

[g-townmach]

Originally Posted by RickyTheStorm

I hope it does haul some ass (don't want it to run faster than 11.5 but I really don't think it will run that fast with the mods I'm doing). Already have the Nitto NT555Rs picked out As far as stronger half shafts, any thoughts on best site to order them from?

I like titan and gforce's half shafts. I thinkfastlane has some too.

http://www.titanmotorsports.com/20casshedure.html

http://shop.gforce1320.com/category.sc?categoryId=36