A10 in a 5th Gen? - Page 2 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

JANNETTYRACING · 10-26-2022, 06:59 AM

Quote:

Originally Posted by Ashen L99

Hey Ted, is there any EFI systems on the market that can control a 10 speed in general other than from GM?

I did a quick search and could not come up with anything, I suspect GM and Ford are being Tight lipped with the control algorithm for this trans.

They don't even offer a stand alone controller yet.

stevieturbo · 10-26-2022, 02:34 PM

I would think the HTG GCU that a lot of people are using for the DCT/DSG swaps could do it.

These generally require direct wiring to all the solenoids/mechatronics inside, and would require a fair bit of R&D legwork for a first time install.

For a modern swap auto, the ZF8HP seems to be the choice for most, ZF8HP70, 75 seem very common, or the ZF8HP90

There are a few control options for those.

I see HTG have taken delivery of a TR9080DCT too for development. Not of any use for a typical front engine in-line setup though

10-26-2022, 02:34 PM	#16
stevieturbo Drives: it changes Join Date: Nov 2010 Location: Norn Iron Posts: 1,126	I would think the HTG GCU that a lot of people are using for the DCT/DSG swaps could do it. These generally require direct wiring to all the solenoids/mechatronics inside, and would require a fair bit of R&D legwork for a first time install. For a modern swap auto, the ZF8HP seems to be the choice for most, ZF8HP70, 75 seem very common, or the ZF8HP90 There are a few control options for those. I see HTG have taken delivery of a TR9080DCT too for development. Not of any use for a typical front engine in-line setup though