03-13-2013, 12:36 PM | #1 |
Drives: 1994 z28, 2010 ss, 2010 titan Join Date: Jul 2012
Location: Warner Robins, Georgia
Posts: 147
|
AAC headlight and foglight halos DIY?
Does anyone have a DIY on how to wire these?
I cant seem to find one or figure out there diagram that came with it. Thanks |
03-13-2013, 12:47 PM | #2 |
Mid-Florida Camaro Club
|
How are you trying to wire them up? I have the AAC foglights and have replaced my RS halos with AAC ones also to match better. Might be able to answer a question or two.
For my headlights, I just wired them back up to the factory wire from the old halo. For my fogs, I disabled the previous bulb by leaving it unplugged and wired the halo to come on the same way the bulb did previously. So both sets of halos are ALWAYS on when the car is on, and then my projectors come on at night with them.
__________________
|
03-13-2013, 12:58 PM | #3 | |
Drives: 1994 z28, 2010 ss, 2010 titan Join Date: Jul 2012
Location: Warner Robins, Georgia
Posts: 147
|
Quote:
|
|
03-13-2013, 01:16 PM | #4 |
Mid-Florida Camaro Club
|
For the tops, bottoms, or both?
__________________
|
03-13-2013, 01:40 PM | #5 |
Drives: 1994 z28, 2010 ss, 2010 titan Join Date: Jul 2012
Location: Warner Robins, Georgia
Posts: 147
|
both
|
03-13-2013, 05:39 PM | #6 |
Mid-Florida Camaro Club
|
First, do this to get your fogs to come on all the time. It's simple and you can it through your wheel wells.
http://www.camaro5.com/forums/showth...ht=drl+harness Then when I installed my fog halos I just tapped the ground and power from the halos into the factory wires in the original plug so they would be powered normally. I did leave the factory bulb in place in the housing though so it would be sealed and nothing would get inside. The halos in the headlight housing were a pain to swap out cause you have to bake them, but you just quick splice the wires from the new ones into the existing wires in the housings.
__________________
|
|
|
Thread Tools | |
|
|