10-22-2012, 10:03 PM | #1 |
COTW 9/16/13
Drives: 2011 2LT/RS Camaro IOM Join Date: Jan 2012
Location: Syracuse
Posts: 10,089
|
Vinyl install help (removing bubbles)
So I tried to install my own vinyl and half of it came out good the other half has terrible bubbles. I tried working them out but had no luck. Does anyone have any suggestions that would help get rid of them? Here are some pics of how bad they are.
|
10-22-2012, 10:51 PM | #2 |
Drives: 2018 Hot Red ZL1 Join Date: Nov 2010
Location: Los Angeles, CA
Posts: 3,599
|
Did u use any.liquid solution or are those air bubbles? You can try and find a seringe.witha very small needle and pinch them and then use the squeguee to get the air.out or even.the.seringe.itself. if u usdd some fluid theyll evaporate after some heat
__________________
|
10-22-2012, 10:51 PM | #3 |
Switchin' n Twitchin'
Drives: 2011 Camaro Join Date: Nov 2010
Location: Chula Vista, CA (Eastlake)
Posts: 3,145
|
You could poke with a needle and release the air...
__________________
I am not childish, you're just being a poopy head!
|
10-22-2012, 11:39 PM | #4 | |
COTW 9/16/13
Drives: 2011 2LT/RS Camaro IOM Join Date: Jan 2012
Location: Syracuse
Posts: 10,089
|
Quote:
Thought about going the needle route but was a little worried I would end up with tiny holes all over that are really noticeable. |
|
|
|
|
|