CAMARO FOSGATE SET UP HELP PLEASE AMP PROB - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

Eteam · 04-30-2014, 10:53 AM

Hello I wanted to know what amp I can use for this set up? Sepperate amp for the subs. and how would I conect the amps to the factory chevorlet 2014 camaro my link? And how would I connect the 4 tweeters to the amp?

2xFront door https://www.sonicelectronix.com/item...wer-T1675.html
2xBack deck https://www.sonicelectronix.com/item...wer-T1693.html
1xFront deck https://www.sonicelectronix.com/item...unch-P132.html
4xTweeter https://www.sonicelectronix.com/item...ate-PP4-T.html
2xSubs Rockford Fosgate P3D4-10 Punch P3 DVC 4-Ohm 10-Inch 500-Watt RMS 1000 Watts Peak Subwoofer by Rockford Fosgate http://www.amazon.com/dp/B004UFHXOC/..._qUrytb0CZFRJJ

jeffa · 04-30-2014, 03:23 PM

My advice, if you have not done any audio installations before, is to have the product professionally installed.

Eteam · 04-30-2014, 06:21 PM

I am I just want to know what I'm talking about when I get there and have the parts in hand.

436SS · 04-30-2014, 06:41 PM

Let us know how your purchase from Sonic goes. Their prices seem to be pretty reasonable.

JimE · 04-30-2014, 07:39 PM

If you have it professionally done, they will create or have everything needed. Some shops won't install (and definetly won't warranty) customer supplied parts.

The front and rear speakers both contain tweeters. I don't know why you would want or need additional tweeters.

The typical install when upgrading amp/speakers is to eliminate the dash speaker.

For amp install, you would need a harness such as the ******** FARK harness, or let the installer create their own.

You're also going to need one, if not two amps and a sub box.

Camaroshark · 04-30-2014, 08:23 PM

If your car has the boston system, you need to go with the ******** FARK harness.

Don't let one of those cheesy shops chop up your wiring in the Camaro.

The ******** kit allows you to plug and play aftermarket amps and all you need is to run power and ground. You can even use the pre out on an aftermarket amp to send signal to a subwoofer amp... Again running power and ground.

Get the FARK kit! You might not even want to change the factory speakers if you include a sub and do the FARK.

Eteam · 05-02-2014, 10:33 AM

Thank you guys for the advice will let you know how everything goes but can someone please tell me what specs I need for the amps.

Knockoutpie · 05-06-2014, 03:16 PM

Looks like you're literally going for the exact same setup I did.

I installed it all myself, same subs, however, I'd change those dual voice coils 4 ohms to dvc 2ohms

http://www.amazon.com/Rockford-Fosga.../dp/B00BF6HYDE
Here's the amp, this amp is perfect for 1 SUB! JUST 1, you'll need to of these amps.

http://www.amazon.com/Rockford-Fosga...&keywords=p3d2

Any questions message me.

04-30-2014, 10:53 AM	#1
Eteam Drives: 2014 Camaro 2lt rs Join Date: Apr 2014 Location: Miami Posts: 3	CAMARO FOSGATE SET UP HELP PLEASE AMP PROB Hello I wanted to know what amp I can use for this set up? Sepperate amp for the subs. and how would I conect the amps to the factory chevorlet 2014 camaro my link? And how would I connect the 4 tweeters to the amp? 2xFront door https://www.sonicelectronix.com/item...wer-T1675.html 2xBack deck https://www.sonicelectronix.com/item...wer-T1693.html 1xFront deck https://www.sonicelectronix.com/item...unch-P132.html 4xTweeter https://www.sonicelectronix.com/item...ate-PP4-T.html 2xSubs Rockford Fosgate P3D4-10 Punch P3 DVC 4-Ohm 10-Inch 500-Watt RMS 1000 Watts Peak Subwoofer by Rockford Fosgate http://www.amazon.com/dp/B004UFHXOC/..._qUrytb0CZFRJJ

04-30-2014, 08:23 PM	#6
Camaroshark Drives: 2010 Camaro 2SS/RS RJT, 6speed Join Date: May 2011 Location: South Florida Posts: 887 View My Garage	If your car has the boston system, you need to go with the ****** FARK harness. Don't let one of those cheesy shops chop up your wiring in the Camaro. The **** kit allows you to plug and play aftermarket amps and all you need is to run power and ground. You can even use the pre out on an aftermarket amp to send signal to a subwoofer amp... Again running power and ground. Get the FARK kit! You might not even want to change the factory speakers if you include a sub and do the FARK. __________________ 2010 Camaro 2SS/RS, LS3 - 6 speed. Mods, Magnaflow exhaust with resonator delete. ****** 12" stealth box subwoofer kit, Kicker 400 mono amp, JL XD 400/4 amp.

04-30-2014, 03:23 PM	#2
jeffa Drives: 2014 2LT/RS Ashen Gray Metallic Join Date: Nov 2011 Location: Redondo Beach, CA Posts: 585	My advice, if you have not done any audio installations before, is to have the product professionally installed.

04-30-2014, 06:21 PM	#3
Eteam Drives: 2014 Camaro 2lt rs Join Date: Apr 2014 Location: Miami Posts: 3	I am I just want to know what I'm talking about when I get there and have the parts in hand.

04-30-2014, 06:41 PM	#4
436SS Drives: 2010 1SS Join Date: Jan 2013 Location: INDY Posts: 271	Let us know how your purchase from Sonic goes. Their prices seem to be pretty reasonable.

04-30-2014, 07:39 PM	#5
JimE Drives: 2013 2SS/RS/1LE Join Date: Apr 2010 Location: St Louis, MO Posts: 3,087	If you have it professionally done, they will create or have everything needed. Some shops won't install (and definetly won't warranty) customer supplied parts. The front and rear speakers both contain tweeters. I don't know why you would want or need additional tweeters. The typical install when upgrading amp/speakers is to eliminate the dash speaker. For amp install, you would need a harness such as the ******** FARK harness, or let the installer create their own. You're also going to need one, if not two amps and a sub box.

05-02-2014, 10:33 AM	#7
Eteam Drives: 2014 Camaro 2lt rs Join Date: Apr 2014 Location: Miami Posts: 3	Thank you guys for the advice will let you know how everything goes but can someone please tell me what specs I need for the amps.

05-06-2014, 03:16 PM	#8
Knockoutpie Drives: 2014 2SS RS Coupe Join Date: Aug 2013 Location: Phoenix Posts: 1,454	Looks like you're literally going for the exact same setup I did. I installed it all myself, same subs, however, I'd change those dual voice coils 4 ohms to dvc 2ohms http://www.amazon.com/Rockford-Fosga.../dp/B00BF6HYDE Here's the amp, this amp is perfect for 1 SUB! JUST 1, you'll need to of these amps. http://www.amazon.com/Rockford-Fosga...&keywords=p3d2 Any questions message me.