Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
SDPC
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Engine | Drivetrain | Powertrain Technical Discussions > Mechanical Maintenance: Break-in / Oil & Fluids / Servicing


Reply
 
Thread Tools
Old 03-09-2017, 01:11 AM   #15
GetYouOne

 
Drives: 2012 2SS/RS
Join Date: Oct 2014
Location: U.S.A.
Posts: 1,586
Thanks Don much appreciated!

Quote:
Originally Posted by hammdo View Post
Myself, I used factory AC/Delco since I get a good deal on it and change it often. Works fine for what I do.

From my build thread:



-Don
GetYouOne is offline   Reply With Quote
Old 03-20-2017, 03:57 PM   #16
thegreatwhite
 
Drives: 2014 SS
Join Date: Aug 2014
Location: Norcal
Posts: 306
has anyone else with a manual SS had the dealer give them a list of recommended services at 45,000 miles. mine did saying i needed some fluids changed etc. it does say this in the manual as well....im wondering how long i can drive the car past 45,000 miles until these services are really needed and not just recommended. any info helps.
thegreatwhite is offline   Reply With Quote
Old 04-03-2017, 02:52 PM   #17
Camaro Dude
and Sledge
 
Camaro Dude's Avatar
 
Drives: '13 1LE, 2SS, NPP
Join Date: Jul 2013
Location: Québec
Posts: 3,717
I can't believe that some of you, are actually following the "suits" service interval recommendations, which is really meant to sweeten the deal for first owner buyers who lease 3 years or so.

I drained mine out, like 2 months after I bought it new, straight from the showroom. There wasn't even a couple thousand on the odometer when I drained it.

I was surprised, almost shocked , to see how dirty it was!!! Very black, and a slight, BUT, nasty odour to the oil. The car had never even seen a track yet..

I've drained/refilled twice since then with Redline 75W/90, car only had like 14000km on it, so in its 3rd fill basically.

It looked very clean on the 3rd drain/flush. Each round of new oil re-fill, saw an approx. equal amount of mileage between intervals.

*The above I wrote, all purtains to the rear diff only, and not the transmission.

The M6 tranny fluid on the other hand, was very clean looking, even after the first drain.
Camaro Dude is offline   Reply With Quote
Old 04-03-2017, 05:10 PM   #18
thegreatwhite
 
Drives: 2014 SS
Join Date: Aug 2014
Location: Norcal
Posts: 306
Quote:
Originally Posted by Camaro Dude View Post
I can't believe that some of you, are actually following the "suits" service interval recommendations, which is really meant to sweeten the deal for first owner buyers who lease 3 years or so.

I drained mine out, like 2 months after I bought it new, straight from the showroom. There wasn't even a couple thousand on the odometer when I drained it.

I was surprised, almost shocked , to see how dirty it was!!! Very black, and a slight, BUT, nasty odour to the oil. The car had never even seen a track yet..

I've drained/refilled twice since then with Redline 75W/90, car only had like 14000km on it, so in its 3rd fill basically.

It looked very clean on the 3rd drain/flush. Each round of new oil re-fill, saw an approx. equal amount of mileage between intervals.

*The above I wrote, all purtains to the rear diff only, and not the transmission.

The M6 tranny fluid on the other hand, was very clean looking, even after the first drain.
ok
thegreatwhite is offline   Reply With Quote
Old 04-09-2017, 04:50 PM   #19
Pete G
 
Pete G's Avatar
 
Drives: 2015 SS 1LE
Join Date: Sep 2014
Location: Long Island, NY
Posts: 123
I checked my manual and for automatic transmission it specified Dexron V1 trans fluid
but for V8 manual it simply says to use " manual transmission fluid "
What suggestions do you guys have for maunual transmission fluid?
Pete G is offline   Reply With Quote
Old 06-17-2017, 10:17 AM   #20
rickjhouston
 
Drives: 2012 SSII
Join Date: Jan 2013
Location: Katy, TX
Posts: 5
Folks - Anyone change their Fluid and Filter themselves?

I've got 76,000 miles on the recommended 72,000 mile change interval. Have never messed with Automatics before. Mechanic Friends are telling me to go for it. The detailed shop manual makes it look pretty straight forward.

Raise car (always fun on these low sitting beasts) / Drop pan / Replace Filter / Re-install Pan using same gasket / Fill Oil / Run to temp - shift all gears / Recheck Fluid Level (back on Jackstands using drain plug method)

My worries -
A) How tough is it to remove &replace the filter? There's not a lot of room with the SS even at the top Jackstand position. Is the filter connection easy and straight forward?

B) the GM Shop manual goes over the top with warnings on not under / over filling the transmission fluid level. Think I can come up with a pump for the tranny fluid. Was going to use the 'Fill from the Drain Plug method'? Is it necessary to run the tranny and recheck the fluid level when the temp is back within the temp range? Without a dipstick - It's raise and lower the Camrow one more time....

Looking for encouragement from those who have done this on their own. The price quoted above is pretty motiving but .....

Thanks - RickJHouston
2012 SS 2
Daily Driver
rickjhouston is offline   Reply With Quote
Old 06-18-2017, 01:50 PM   #21
hammdo
'It's an experiment'
 
hammdo's Avatar
 
Drives: [COTW 2/09/15] '11 L99 LSA SC Z/LE
Join Date: May 2014
Location: Dallas TX
Posts: 5,237
http://www.camaro5.com/forums/showpo...48&postcount=8

Should help. The Jannetty dipstick really should be a mandatory upgrade for autos ;o)

-Don
hammdo is offline   Reply With Quote
Old 06-20-2017, 09:30 PM   #22
rickjhouston
 
Drives: 2012 SSII
Join Date: Jan 2013
Location: Katy, TX
Posts: 5
Thanks, Hammdo (Don). The post on the Tranny Pan change and both Dipstick installations have inspired me to give the Filter and Fluid change a try.

Think I'll start by seeing if I can get the Dipstick plug out. If I can do that - than only worry I can see is removing & installing the filter seal.

For Filling - I've got a pretty good length of 1/2" Clear Hose. Thinking I can run it down from the Firewall into the Dipstick port.

Again - the post with pictures was super helpful. Have to wonder when GM will go this route for Shop manuals.

Much Appreciated and Regards - Your Texas Brother - RickJHouston
rickjhouston is offline   Reply With Quote
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:58 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2017, vBulletin Solutions, Inc.