11-15-2015, 05:00 PM | #1 |
Drives: 93GMC sierra stepside/ ctsv3 Join Date: Dec 2011
Location: San Antonio, Texas
Posts: 914
|
Clutch master Hard line O-Ring size?
So I was swapping out my master cylinder that I got from ideal garage and I guess there is and o-ring that goes over the plastic piece on the hard line that clips into the bottom of the master, mine must have fallen off when I pulled the stock on out and I can not find it. does anyone happen to know the size of that oring so I can go get a replacement..
Would prefer not to go to the dealer and ask as I would like to get it back together tonight.. Thanks a lot for any help |
11-17-2015, 03:23 PM | #2 |
Drives: 93GMC sierra stepside/ ctsv3 Join Date: Dec 2011
Location: San Antonio, Texas
Posts: 914
|
No one huh..
I picked up a few different sizes so ill see what one fits the best and don't leak when I try and bleed it this weekend |
12-02-2015, 10:37 AM | #3 |
In The Circle
Drives: 2010 Camaro 2SSRS IOM M6 Join Date: May 2009
Location: Abbotsford BC Canada
Posts: 11,292
|
I don't believe the o-ring is available separately from the dealer apparently the ring comes with the hard line only. We had to reuse the old one when I replaced the slave.
__________________
Last edited by Merc; 12-02-2015 at 09:58 PM. |
12-02-2015, 12:01 PM | #4 |
Drives: 2010 Camaro 2SS Join Date: Nov 2015
Location: Ohio
Posts: 84
|
|
12-06-2015, 09:52 AM | #5 |
Eh, that'll happen
Drives: 2010 2SS Join Date: Apr 2012
Location: Mesa, Arizona
Posts: 1,841
|
Im doing mine today with a new Tick feed line. Have any advice? Ive been pushing this off because it looks like a bitch job. But my clutch pedal stopped coming up so I dont have a choice. Haha!
__________________
2010 Camaro SS LS3 - No Modz
|
12-07-2015, 05:49 PM | #6 | |
In The Circle
Drives: 2010 Camaro 2SSRS IOM M6 Join Date: May 2009
Location: Abbotsford BC Canada
Posts: 11,292
|
Quote:
__________________
|
|
12-08-2015, 11:45 PM | #7 |
Drives: 2012 2SSRS Vert, Black w/M6 Join Date: Jan 2013
Location: Montgomery, AL
Posts: 1,265
|
I have some at the shop, I'll post up the size. They have to be EPDM rubber, or they won't last long. They are a standard o-ring size.
|
09-04-2016, 11:49 AM | #8 |
Drives: 2012 Camaro 1SS M6 Join Date: Sep 2014
Location: Spring Hill, FL
Posts: 184
|
6 ID 10 OD 2 W should be the correct size...not trying to bring a thread back from the dead just trying to help future seekers...but yes EPDM is necessary
|
|
|
|
|