07-05-2013, 08:34 PM | #1 |
Drives: none (yet) Join Date: Jul 2012
Location: The Villages, FL
Posts: 1,131
|
Zl1 wheels question
Will the 20x10 wheels fit in the rear as well?
|
07-05-2013, 08:52 PM | #2 |
Drives: 2SS/RS CGM LS3 Join Date: Aug 2009
Location: NJ
Posts: 1,619
|
No... A +23 in the rear will stick out bad. You can get the Factory Reproduction ZL1's in 20x10 +35 that will work.
|
07-05-2013, 10:00 PM | #3 |
Drives: none (yet) Join Date: Jul 2012
Location: The Villages, FL
Posts: 1,131
|
|
07-05-2013, 11:31 PM | #4 |
|
Withe a strait edge at the center off the wheel it will be about 5/16 to 3/8 pass the outer fender , but it will look more than that visually
|
07-06-2013, 12:08 AM | #5 |
Drives: none (yet) Join Date: Jul 2012
Location: The Villages, FL
Posts: 1,131
|
Damn. I don't want to get the factory repros and I'm getting a great deal on these 4 front wheels
|
07-06-2013, 01:19 AM | #6 |
Drives: 2013 SS Join Date: May 2013
Location: DFW
Posts: 4,102
|
I'd say try them out and see 1st before you buy. You could always sell the other 2 just a thought.
__________________
|
07-06-2013, 01:19 PM | #7 |
Drives: none (yet) Join Date: Jul 2012
Location: The Villages, FL
Posts: 1,131
|
okay. that being said is sticking out a little the only problem? i.e. will fit with the rotors and cables fine
|
07-06-2013, 10:00 PM | #8 |
|
It should clear all of that
But again , if you go to a delar that has a ZL1 on the lot , take a look at the rears , the wheels do stick out just about 3/8 pass the fender , if you stick a strait edge , you will see exactly what we are talking about |
|
|
|
|