2010 Camaro 2SS/RS M6 w/ Bolt-On's $23.5k

[djpelosi]

I am listing my 2010 Camaro SS for sale. Looking to purchase a C7 Corvette which is the reason for selling. The car is a 6 speed manual transmission with the LS3 motor, and has the 2SS/RS package. The car drives perfect. It has taken down multiple new bolt-on 5.0 Mustangs with ease. The car has just about every performance bolt-on you can put on it (other than suspension mods), and is ready for a cam swap or supercharger. I've already laid the groundwork for you to turn this car into a real beast. The car ran 12.43 @ 114 with bolt-on's only, stock weight and stock tires. This is an extremely good time for this car especially without a tune and DRs. I do not have any HP numbers since I have not yet dyno'd it. This particular color scheme on the car (Black w/ Inferno Orange Metallic interior and stripes) is very rare. I've owned two 2010's with this scheme, and both cars had to come from Atlanta because nobody else closer had this same color combo for sale. There are probably a few things I'm forgetting, so feel free to ask any questions you may have. I'm asking $23,500 and car is located in Memphis, TN. Full list of mods below

FYI: This car is extremely loud due to having no cats, resonators, or mufflers (mainly on a cold start, and when you're wide open throttle). Once it's warmed up, it's not bad at all, especially at a cruise. You can easily have a conversation in the car. But know that when you go wide open throttle, you'll be heard from several miles. Here is a YouTube link to my car at idle (tail lights have been tinted since I took this video)

#####################################

PERFORMANCE
---------------------------
2" XS Power longtubes (Cat, resonator & muffler delete) - Installed 6/01/2014
3" Flowmaster h-pipe straight to the tips - Installed 6/01/2014
Hurst short throw shifter - Installed 6/20/2014
Bo White ported throttle body - Installed 6/27/2014
Cold Air Inductions CAI w/ Rotofab Washer Relocate - Installed 12/16/2014

COSMETIC
---------------------------
5% side/rear tint, 35% windshield tint - Installed 8/25/2013
Mesh front upper grille - Installed 12/20/2013
Door panel ambient lighting extension + double LED mod on door panels - Installed 4/13/2014
Dash ambient lighting - Installed 4/13/2014
Mesh front upper grille - Installed 7/15/2014
Heater hose relocate - Installed 10/17/2014
Fuel rail flip - Installed 11/1/2014
Evap solenoid relocate - Installed 11/6/2014
Painted intake manifold, fuel rails and throttle body - Installed 11/6/2014
Painted valve covers and coil pack brackets - Installed 11/8/2014
EmblemPros.com custom made LS3 front upper grille emblem - Installed 1/15/2015

CONS:

Driver side front wheel as light curb rash

There are some small door dings here and there... typical for a 5 year old car. It could use a good detail.

The dash ABL is not currently hooked up. When I installed it, I used electroluminescent light tape instead of an LED pipe, and it went out not too long ago. The wires are still behind the molding and can be easily hooked up again if you decide to purchase a light pipe kit from someone online. Otherwise, you can't even tell there's been a dash abl mod.

[BeginLOL]

Nice car. I love that interior. Crazy your selling, but I can see for the vette. Test drove a Stringray this past weekend and I was almost sold on it. GLWS,

[djpelosi]

Bump for new price $23,500. Found the Vette I want so I need this gone.

[djpelosi]

Bump

[djpelosi]

Bump.

[djpelosi]

Bump for offers