01-03-2024, 07:48 PM | #1 |
BBL-BEE
|
Help With Wire Pass-Throughs
I'm going to install some cheep exhaust cutouts and they are powered by a cigarette lighter, are there any passthroughs underneath the car that I could use preferably near the cats is where I am going to install them. thanks for the help
__________________
Nuthin' But Bolt On's: eBay 1-7/8" Long Tube Headers, SLP Blackwing Cold Air Intake, Phastek Race Scoop, 3" Maximizer Exhaust + 3" Muffler Delete In-To 4" Chrome Tips, Taylor "409" 10.4MM Wires.
No Thoughts.......Head Empty |
01-04-2024, 07:42 AM | #2 |
Drives: 2010 Turbo LS3 Join Date: Dec 2009
Location: Palm Bay, FL
Posts: 2,845
|
There is a drain plug on each side you can poke a hole in. Only downside I have found is using them routs the wire close to the exhaust presenting the opportunity to melt a wire, so I used silicone covered fiberglass loom to protect the wires after they melted the first time.
__________________
2010 SS - Kind of an On3 kit, CTR 78/80, CompCam 239/251 620/632 122+4, E85, Z28 suspension and ZL1 diff with Outlaw axles. Gen6 ZL1/1LE brakes.
2011 Vert - 416/w 230/236 .612/.602 115lsa, 1LE suspension w/32mm rear bar. Z28 diff. ZL1 brakes. |
|
|
|
|