You are browsing camaro5 
 |
|
05-21-2013, 12:54 AM
|
#1 |
 Drives: 2010 Camaro 2SS/RS Join Date: Feb 2013
Location: Georgia
Posts: 229
|
Suspension question
If I lower my car with Eibach lowering springs, do I NEED to put anything else on the car suspension wise? Or will it be all fine and dandy?
__________________
2010 2SS/RS- every option possible in 2010
 Lighting- LED footwell, grille, trunk, and engine lights done via DIY. LED dome, DRL, and tag lights. Paint- Painted engine cover, steering wheel bezel, speedometer bezel, front bowtie, tail light bezels, wheel center caps. Exterior lights- tinted tail lights and sidemarker lights. Wheels- powdercoated stock RS 20' wheels black Exhaust- Cat-back Dynomax Bullet Exhaust system with bullet muffler delete. Misc- rear blackout kit from Big Worm Graphix, black side Camaro lettering from Emblem Pros, and rear Camaro lettering from Emblem Pros. |
|
|
|
05-21-2013, 05:26 AM
|
#2 |
Drives: 2000 Camaro SS Join Date: Feb 2010
Location: Louisville, Ky.
Posts: 25,179
|
Nothing else is required for lowering springs installation.
|
|
|
|
|
05-21-2013, 05:49 AM
|
#3 |
|
Account Suspended
|
Nothin else is required mate, you're set.
|
|
|
|
|
05-21-2013, 11:34 AM
|
#4 | |
       
Drives: Varies Join Date: Dec 2009
Location: Costa Mesa, CA
Posts: 2,182
|
Quote:
Unless you are going to be doing more than DD, but that's a whole different topic. JT |
|
|
|
|
|
05-21-2013, 11:53 AM
|
#5 |
Drives: Chevys at the limit Join Date: Nov 2010
Location: SLC, UT
Posts: 9,621
|
Just an alignment once your done!
Best regards, Tyler 888-308-6007 |
|
|
|
|
05-24-2013, 10:51 AM
|
#6 |
Drives: 2010 Camaro, 2006 Z06 Join Date: Feb 2009
Location: SLC, UT
Posts: 3,370
|
Yep, good to go! Just make sure you get your camber checked
|
|
|
|
|
|
|
|
 |
|
|
