06-26-2012, 06:56 PM | #1 |
Drives: 2011 RJT Camaro LT2 RS auto shift Join Date: Dec 2011
Location: Washington state
Posts: 1,861
|
Metra dash kit
How easy is the Metra kit to install? I might have to trash the Scosche kit. I have a problem with a dead battery every once in a while. 3 times since March.
__________________
Caddy
|
06-26-2012, 07:40 PM | #2 |
Drives: 2011 IOM 2SS/RS L99 convertible Join Date: Jan 2012
Location: Birmingham, AL
Posts: 131
|
It installs relatively the same might even be a little easier, with better directions.
|
06-26-2012, 08:12 PM | #3 |
Drives: 2011 RJT Camaro LT2 RS auto shift Join Date: Dec 2011
Location: Washington state
Posts: 1,861
|
Never mind it does not need any thing for Onstar to work
__________________
Caddy
Last edited by Caddyroger; 06-26-2012 at 08:32 PM. |
06-26-2012, 10:47 PM | #4 |
Drives: 2011 IOM 2SS/RS L99 convertible Join Date: Jan 2012
Location: Birmingham, AL
Posts: 131
|
It will work fine with a fark harness or stock speakers and stock amp. Gets a little tricky when you run all new wires, speakers and amp. I used my center speaker tapped in to the front left output of kit harness before it hooked into factory harness. On the scosche kit I added an eight ohm resistor to the postive speaker wire to lower the volume. Metra kit should be able to use the black/yellow wire to adjust volume per directions. With schosche kit I get chimes, backup chimes, and blinkers through built in speaker on backside of touch screen, Onstarr and factory Bluetooth comes through center speaker.
|
06-27-2012, 05:42 AM | #5 |
Drives: 2012 CHEVROLET CAMARO ZL1 (BLACK) Join Date: Aug 2011
Location: TEXAS
Posts: 63
|
Can I add the Metra Dash kit to the ZL1? Won't it mess up the HUD on it or everything will be the same?
|
06-27-2012, 07:40 AM | #6 |
Drives: 2011 IOM 2SS/RS L99 convertible Join Date: Jan 2012
Location: Birmingham, AL
Posts: 131
|
I believe the zl1 and all camaros so far use the same dash kits. Will not mess up HUD just will not show song title.
|
07-02-2012, 01:25 PM | #7 |
Drives: 2012 CHEVROLET CAMARO ZL1 (BLACK) Join Date: Aug 2011
Location: TEXAS
Posts: 63
|
I cannot get OnStar to work, so I need the 12K ohms resistor, so where the heck do I put that? Everything else works but Onstar, PTT and Mute button from the steering wheel.
|
|
|
|
|