LG Motorsports Velocity CAI system

[Anthony @ LG Motorsports]

Hey guys,

Looking for a killer cold air system that has been track and race proven? LG Motorsports Velocity CAI system is just what you need. Our system includes a full 4" intake tube with built in velocity stack inlet, high flow air filter, heat shield, hood seal, coupler, and clamps.

We believe in it so much that we adapted it to run on our own World Challenge Camaro (see below with required series restrictor in place)

The kit is finished in a durable semi gloss black finish and includes the re-usable high flow filter for years of use.

Assembled


Velocity stack inlet

Again, taken from our years of racing we built in a full velocity stack as part of our inlet ducting so it does not deform in in some of the rubber units found in other kits.

Exploded View

-Full system to bolt onto your Camaro SS

Air Intake Temp on track

-Notice even on track with the engine over 230 degree's!


Dyno Results

-No other changes and almost 15hp at the rear wheels!


Modified version for the race car

-shown here modified to use the series required restrictor.

[Anthony @ LG Motorsports]

Reposted....will post outside to engine air test data this week.

[2SSCAMARO]

Originally Posted by Anthony @ LG Motorsports

Hey guys,

Looking for a killer cold air system that has been track and race proven? LG Motorsports Velocity CAI system is just what you need. Our system includes a full 4" intake tube with built in velocity stack inlet, high flow air filter, heat shield, hood seal, coupler, and clamps.

We believe in it so much that we adapted it to run on our own World Challenge Camaro (see below with required series restrictor in place)

The kit is finished in a durable semi gloss black finish and includes the re-usable high flow filter for years of use.

Assembled


Velocity stack inlet

Again, taken from our years of racing we built in a full velocity stack as part of our inlet ducting so it does not deform in in some of the rubber units found in other kits.

Exploded View

-Full system to bolt onto your Camaro SS

Air Intake Temp on track

-Notice even on track with the engine over 230 degree's!


Dyno Results

-No other changes and almost 15hp at the rear wheels!


Modified version for the race car

-shown here modified to use the series required restrictor.

How do you prevent detonation on a super hot engine cranking 5800 RPM's with 44.5 degrees advance timing?

[Anthony @ LG Motorsports]

Originally Posted by 2SSCAMARO

How do you prevent detonation on a super hot engine cranking 5800 RPM's with 44.5 degrees advance timing?

Check throttle position....only 30%, not WOT. Going corner exit you would not be on the throttle WOT depending on where you are in the corner.

[John Deere Racer]

Damn nice piece

I made 430rwhp
With this And lg headers

[Anthony @ LG Motorsports]

Originally Posted by John Deere Racer

Damn nice piece

I made 430rwhp
With this And lg headers

And got the car in the low 12's too......right?

[Fish-man]

pics aren't showing?

[Baltimorejohn1]

Nice setup and race proven always validates you definitely trust it to perform.....

[Anthony @ LG Motorsports]

Originally Posted by Baltimorejohn1

Nice setup and race proven always validates you definitely trust it to perform.....

My point exactly.

[Top Off]

So no tune is required?