Exhaust question - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

faninc · 01-19-2020, 09:47 PM

Hi All,

I have a 2014 2LT RS. I installed axle back exhaust. Simply cut exhaust pipes slid over the new system and clamped. Now after two years looking to put back stock OEM mufflers. Anyone know what coupler I will need to use so as to fit over each end of my cut? Thanks!

rickyrocket · 01-20-2020, 09:55 AM

Use a band clamp,available at any parts store, probably 2.5 inch

faninc · 01-21-2020, 06:32 AM

I found out the exhaust down at the muffler area is 2 1/4” pipe. I needed a 2 1/4ID and OD coupler to rejoin the stock muffler to the exhaust pipe. Will weld both ends. Thanks

SlickbackJr · 01-27-2020, 06:45 PM

Can I just ask why u went back to stock?

01-19-2020, 09:47 PM	#1
faninc Drives: 2010 Camaro RS in SIM Join Date: May 2009 Location: NJ Posts: 563 View My Garage	Exhaust question Hi All, I have a 2014 2LT RS. I installed axle back exhaust. Simply cut exhaust pipes slid over the new system and clamped. Now after two years looking to put back stock OEM mufflers. Anyone know what coupler I will need to use so as to fit over each end of my cut? Thanks!

01-20-2020, 09:55 AM	#2
rickyrocket Drives: 2015 blk 1 SS Join Date: May 2012 Location: Coventry RI Posts: 1,309	Use a band clamp,available at any parts store, probably 2.5 inch __________________ 15 1 SS

01-21-2020, 06:32 AM	#3
faninc Drives: 2010 Camaro RS in SIM Join Date: May 2009 Location: NJ Posts: 563 View My Garage	V6 exhaust I found out the exhaust down at the muffler area is 2 1/4” pipe. I needed a 2 1/4ID and OD coupler to rejoin the stock muffler to the exhaust pipe. Will weld both ends. Thanks

01-27-2020, 06:45 PM	#4
SlickbackJr Drives: 2010 Camaro LT Join Date: Mar 2017 Location: California Posts: 25	Can I just ask why u went back to stock?