05-24-2014, 10:55 AM | #519 |
Drives: 2010 2SS/RS IBM / Silver Stripes Join Date: Mar 2010
Location: Northeast Michigan
Posts: 601
|
|
06-13-2014, 03:03 PM | #520 |
Drives: 2010 1SS M6 460rwhp Join Date: May 2014
Location: Phoenix, AZ
Posts: 84
|
|
06-13-2014, 03:06 PM | #521 | |
Drives: 2010 1SS M6 460rwhp Join Date: May 2014
Location: Phoenix, AZ
Posts: 84
|
Quote:
Probably about 10/10 less |
|
06-13-2014, 03:08 PM | #522 |
Drives: 2010 1SS M6 460rwhp Join Date: May 2014
Location: Phoenix, AZ
Posts: 84
|
LMR CAI
Manzo 2 inch headers/x-pipe/some brand of mulller (full $800 exhaust kit) Tick Stage 2 Blower Cam (super good driveability) Needless to say I am happy. Time to save for a blower/clutch/suspension 454rwhp/424rwtq 368rwhp/366rwtq (stock baseline with muffler bypass) Here is the 454 run on boobtube http://youtu.be/Z-sxWPPAGd8 |
06-14-2014, 02:40 PM | #523 |
Drives: 2010 1SS M6 460rwhp Join Date: May 2014
Location: Phoenix, AZ
Posts: 84
|
|
06-27-2014, 10:28 AM | #524 |
Drives: 2013 AGM 1SS/RS LS3 Join Date: Mar 2011
Location: Cedar Falls, Iowa
Posts: 1,581
|
Here is my dyno sheet finally. Mods are as follows:
CAI Inductions intake VMax PTB Dynatech LTH 1.875" Apex Scoop w/ Washer relocator NPP exhaust
__________________
2013 Camaro 1SS/RS - Ashen Gray Metallic
| LS3 | CAI Inductions, Inc Intake | Vmax Ported Throttle Body | Dynatech 1.875" Long Tube Headers | Apex Scoop & Washer Bottle Relocation | Lethal Racing Night Fury Cam | BTR 7.400" Push Rods |LS2 Dampener | Melling 10296 Oil Pump | IWIS Chain | BTR .660" Dual Valve Springs | BTR Trunion Upgrade Kit | Lethal Racing Tuned | Anvil Notch Spoiler | BMR Split Drop Springs | Eaton TrueTrac | GM 3.91 Gears | LPW Diff Cover | Rohana RF2 275/40 20x10F 315/35 20x11R | BMR Polyurethane Motor Mounts |
07-08-2014, 10:15 AM | #525 |
Drives: 2010 CGM Camaro 2SS/LS3 Join Date: Oct 2013
Location: Raleigh-Durham
Posts: 1,409
|
2010 Camaro 2SS LS3
Stainless Power longtubes High flow cats Flowmaster American Thunder 3" cat back K&N Typhoon CAI Hurst short throw Tune by RPM Motorsports in Garner NC 393HP/396TQ Pre-tune 421HP/420TQ Post-Tune
__________________
2010 2SS
BMR 1" Springs Koni Orange struts/shocks 1LE rear sway bar SRP Racing Pedals Hurst Billet short shifter Square tire/wheel setup Elite Engineering Catch Can Stainless Power longtubes/highflow cats K&N Typhoon CAI RPM Motorsports of Garner, NC dyno tune (421 RWHP) |
07-29-2014, 03:53 PM | #526 |
USMC OIF 06-08
|
Comp Cam 227-239 115+3
Kooks LT Headers and Catted Connection Pipes Factory NPP Exhaust, Fuse Pull Roto Fab Cold Air Intake Full Street and Dyno Tune
__________________
Last edited by M3hta1; 08-12-2014 at 09:25 PM. |
08-12-2014, 08:13 PM | #527 |
Drives: 2012 Camaro SS M/T Join Date: Mar 2014
Location: Florida
Posts: 14
|
Pat G custom cam
2012 Camaro ss
M/T stock clutch Kooks stepped headers 1-3/4 to 1-7/8 Kooks full exhaust 3 inch no cats Halltech intake SLP pulley Custom cam by Pat G 231/238 91 pump gas 45% humidity 36c temp 485 rwhp 453 rwtq |
08-31-2014, 12:21 AM | #528 |
Drives: 2ssrs Join Date: Jul 2014
Location: Orange County
Posts: 145
|
Love the dyno sheets and this thread! Good to see solid tuning shops around, unlike the trash we have here in SoCal (especially the one in Murrietta).
__________________
2010 Camaro 2SS/RS*
*SLP TVS 2300 SuperCharger* *SLP Engine Covers & SLP Boost Gauge Kit* *3.6 Jannetty Pulley*CAI Intake* *Elite CatchCan*VMax Throttle Body* *Stainless Power LT w/HF Cats*ID 85's* *Eibach Pro Kit* *VIS Racing Terminator CF Hood & Trunk*Eibach Pro Kit* |
08-31-2014, 11:38 AM | #529 |
Drives: 1989 GTA Trans Am Join Date: Jun 2012
Location: Cypress, California
Posts: 610
|
"unlike the trash we have here in SoCal (especially the one in Murrietta)."
He did a good job on my car. I was very satisfied. |
09-01-2014, 04:47 PM | #530 |
Drives: 2010 infeno orange ss camaro Join Date: Feb 2013
Location: colton,ca
Posts: 89
|
Where did you go.
__________________
2010 INFERNO ORANGE SS. VARARAM,BBK LONG TUBE HEADERS,GPI SS3 CAMSHAFT, 3.91 GEARS, 444RWHP 400FPT.
|
09-01-2014, 06:59 PM | #531 |
Drives: 1989 GTA Trans Am Join Date: Jun 2012
Location: Cypress, California
Posts: 610
|
Cunningham Performance in Murietta.
|
09-16-2014, 11:33 AM | #532 |
Drives: Magna Charged 2011 SS/RS M6 Join Date: Aug 2014
Location: Huntsville Al
Posts: 68
|
2011 SS M6
Maggie Supercharger with handheld tune
No other modifications. Just purchased vehicle so this is just a base test. 524 hp 509 torque |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LS3 dyno results | TinyToasta | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 15 | 05-14-2012 08:14 AM |
LS3 and L99 engine dyno test | ULTRAZLS1 | 5th Gen Camaro SS LS LT General Discussions | 20 | 09-27-2010 11:52 AM |
Texas Speed Engine Dyno L99 Baseline Vs. LS3 Baseline | Jon@Texas-Speed | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 6 | 07-21-2010 03:55 PM |
What's the highest HP/TQ dyno #'s on the site for a STOCK LS3? | topgun1 | 5th Gen Camaro SS LS LT General Discussions | 38 | 03-24-2010 08:57 PM |
My dyno #'s on a stock LS3 | victoryred1ss | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 4 | 03-18-2010 04:05 PM |