08-05-2012, 01:36 PM | #1 |
can't open door
So I had my handle removed and my door fully shut now I can't open the door even from the inside handle. How should I go about fixing this problem?
|
|
08-05-2012, 01:42 PM | #2 |
COTW 9/16/13
Drives: 2011 2LT/RS Camaro IOM Join Date: Jan 2012
Location: Syracuse
Posts: 10,089
|
Unlock it
|
08-05-2012, 01:49 PM | #3 |
Lol I wish it were that simple
|
|
08-05-2012, 01:56 PM | #4 |
knows 2 facts about ducks
Drives: ...and they're both wrong Join Date: Aug 2009
Location: The HMS Invincible
Posts: 25,072
|
Did you remove the interior door panel during the install?
|
08-05-2012, 01:56 PM | #5 |
Mid-Florida Camaro Club
|
Pop the trunk. Climb in through there?
__________________
|
08-05-2012, 02:00 PM | #6 |
Shark attack!
|
Connection has to be re adjusted.
__________________
|
08-05-2012, 02:07 PM | #7 |
No I didn't Unfortunatly. Is it possible to remove from the inside of the car?
|
|
08-05-2012, 02:25 PM | #8 |
knows 2 facts about ducks
Drives: ...and they're both wrong Join Date: Aug 2009
Location: The HMS Invincible
Posts: 25,072
|
The interior door panel? Yes. I've done it a dozen times or so.
|
08-05-2012, 02:50 PM | #9 |
Okay good. And I should be able to adjust the door to open then?
|
|
08-05-2012, 04:13 PM | #10 |
Okay I have gotten a few parts. Now it say I have to remove 3 screws. I can't get to ten with the door closed
|
|
08-05-2012, 04:24 PM | #11 |
I've got it popped away from to sill a bit but I can't get to the door latch because it is on the other side of the window.
|
|
09-27-2012, 10:39 AM | #12 |
Bump
|
|
09-27-2012, 11:31 AM | #13 | |
Drives: 2010 SGM 1LT (Manual) Join Date: Sep 2010
Location: Wetumpka, AL originally NY
Posts: 368
|
Quote:
Or you can climb out the window.
__________________
2010 SGM Manual Trans
Mods: Flowmaster, Solar Gard Window Tint, Front Bowtie from Gary's Customs, Green LED dome & trunk lights from AAC, Painted calipers used G2 paint, Emblem Pro underhood bowtie, Stealth Bulb turn signals. |
|
04-03-2013, 03:27 PM | #14 |
Well I fixed the problem back during Thanksgiving Break. Figured id get back to here in case anyone else has the same problem.
Because the red between the handle and the latch was fixed in place, I just had to cut the thin rod and pull up on the latch half. Opened right up. Just had to rig the cut rod so that it stayed in line and was still stiff. |
|
|
|
|
|