05-11-2016, 09:40 PM | #1 |
Drives: 2010 ss Join Date: Oct 2015
Location: windom mn
Posts: 337
|
one bolt cam torque value
I take it that the one bolt cam has a tty bolt in it,so it is right to torque it to 55lbs and a 50 degree turn.so how much is 50 degrees? little past 3:00 oclock?
|
05-11-2016, 10:39 PM | #2 |
Drives: 2011 2SS/RS M6 Join Date: Oct 2015
Location: Utah
Posts: 1,940
|
3 o'clock would be 90 degrees. A full circle is 360 degrees. It would be more like 1:30
|
05-12-2016, 04:57 AM | #3 |
Drives: 2010 ss Join Date: Oct 2015
Location: windom mn
Posts: 337
|
ok thanks
|
05-12-2016, 05:41 AM | #4 |
Drives: 2011 Camaro SS Join Date: Mar 2011
Location: theD
Posts: 48
|
Just a helpful reminder, don't do what I just did. I had the cam gear installed correctly in the alignment hole....then when I almost had the bolt tight I switched to my torque wrench....in doing so I accidentally pushed the cam back enough to allow it to rotate and have the alignment pin come out. I tightened it and damaged the pin slightly...now I'm working with a machine shop to use an edm to remove the pin and install a new one....huge PITA
|
05-12-2016, 05:50 PM | #5 |
Drives: 2010 ss Join Date: Oct 2015
Location: windom mn
Posts: 337
|
thanks for the heads up...
|
05-12-2016, 10:02 PM | #6 |
Drives: 2011 2SS Join Date: Aug 2014
Location: Sacramento
Posts: 341
|
3 bolt would've been better. That single bolt is a bad design. I've used a dollar store protractor? I think that's the name of it. Measures angle and was in the school supplies section.
|
05-15-2016, 11:28 AM | #7 |
Drives: 2010 ss Join Date: Oct 2015
Location: windom mn
Posts: 337
|
if I was to cam the car,i would go with the 3 bolt cam.I have a full nitrous kit with fuel cell and all.I like the way the car runs with full bolt ons.Thinking 150 shot,better then the 50-60 from a cam and tune.plus the torque is super on spray.lol just got done with a new cam chain,chain damper and melling high volume pump and of course cross member bolt in mod and oil pan gasket.thanks for the replys guy,love this forum!!
|
05-15-2016, 06:27 PM | #8 |
Drives: 2010 Chevrolet Camaro 2SS/RS Join Date: Dec 2015
Location: Massachusetts
Posts: 229
|
TTY bolts are one time use. Hope you used a new cam gear bolt!
__________________
2014 Sierra Denali 6.2 ... Daily Driver
2012 Camaro ZL1... m6 stock toy 1999 Trans Am... Waiting for a new heart |
05-16-2016, 04:36 PM | #9 |
Drives: 2010 ss Join Date: Oct 2015
Location: windom mn
Posts: 337
|
yeap got one comming
|
|
|
|
|