02-25-2013, 07:25 PM | #1 |
|
Water Injection NOOB
So so this is not about my car. I have boosted my 2007 GSXR 600. Im running about 6psi with a GT2560R turbo. I am not running a intercooler. I was looking to get advice on some water injection kits. The bike will be driven daily and raced at the same time. My compression is 12.5:1 right now witch is stock for this bike. I was wondering if I need the water kit and how much one would be for what I have. What kind of water do I run in it? Ive been told windshield wash fluid works fine. ill need something kinda cheap cause I will be going threw a lot of it. The bike has not been put on the dyno just yet. Can I have the water system kick on at 4psi and kick off when the pressure drops below 4? and where do you install the jet over each cylinder or just in the front part of my intake?
__________________
MODS 6.0 forged iron block, TH400, B&M shifter, DSS axles & driveshaft, Viking / BMR suspension, Full custom fuel system with cell, Twin 76mm teriyaki tornados on 24lbs.
https://www.instagram.com/whoopa_ss/ |
02-25-2013, 07:42 PM | #2 | |
Drives: 11 F150 EB/13 Sonic RS/15 Z06 Join Date: Sep 2010
Location: Little Rock, AR
Posts: 7,129
|
Quote:
__________________
New Ride -- 2015 Z06 2LZ (stock) -- Journal
Old Ride -- 2012 Camaro 2LT/RS (647 RWHP & 726 RWTQ) -- Build Thread |
|
02-25-2013, 08:16 PM | #3 |
Always bet on Black
Drives: 2011 turbo LS, 2012 f 150, Join Date: Nov 2010
Location: Concord Nc
Posts: 1,983
|
Place it after the air filter like nos kit will be the best place. If you can get a nos spray bar tie the meth injector into it. Most of the guy I know run a 50/50 or 60/40.
Sent from my iPad2 on space mountain |
02-26-2013, 12:27 AM | #4 |
|
here is the set-up.
__________________
MODS 6.0 forged iron block, TH400, B&M shifter, DSS axles & driveshaft, Viking / BMR suspension, Full custom fuel system with cell, Twin 76mm teriyaki tornados on 24lbs.
https://www.instagram.com/whoopa_ss/ |
|
|
|
|