You are browsing camaro5 
 |
|
06-04-2013, 03:02 PM
|
#1 |
 Drives: 2010 Camaro 2SS/RS Join Date: Feb 2013
Location: Georgia
Posts: 229
|
DIY brake caliper painting
removed wheels, painted the calipers with the Duplicolor kit from Auto Zone. SUPER easy and did not leave any brush strokes. still have lots of paint left after 4 coats on each. i did not remove and paint either. just taped off and painted what you can see with the wheel on.
__________________
2010 2SS/RS- every option possible in 2010
 Lighting- LED footwell, grille, trunk, and engine lights done via DIY. LED dome, DRL, and tag lights. Paint- Painted engine cover, steering wheel bezel, speedometer bezel, front bowtie, tail light bezels, wheel center caps. Exterior lights- tinted tail lights and sidemarker lights. Wheels- powdercoated stock RS 20' wheels black Exhaust- Cat-back Dynomax Bullet Exhaust system with bullet muffler delete. Misc- rear blackout kit from Big Worm Graphix, black side Camaro lettering from Emblem Pros, and rear Camaro lettering from Emblem Pros. |
|
|
|
06-05-2013, 08:22 PM
|
#2 |
|
Whipped
|
Did the g2 caliper paint on my solstice and flex... chipped off in months...powder coated the camaro. Good luck.. always looks great first two months.
__________________
|
|
|
|
|
06-05-2013, 08:23 PM
|
#3 |
       
Drives: 2010 Camaro SS, 2018 Colorado Join Date: Nov 2009
Location: NC
Posts: 2,207
|
That's clean, well done.
|
|
|
|
|
06-05-2013, 08:36 PM
|
#4 |
Drives: '11 SW 1LT RS Join Date: Aug 2012
Location: Granite Bay, CA
Posts: 717
|
I have had mine for close to 6 months. I would give it a 9/10 compared to the day I did it. Not bad for a few bucks and a little of my time. I would recommend it. great job man.
__________________
 |
|
|
|
|
06-05-2013, 09:22 PM
|
#5 |
|
Retired from Car mfrs....
Drives: 2LT RS/HR-V Join Date: May 2013
Location: /Fort Lauderdale
Posts: 10,048
|
no luck brushing on the duplicolor kit, but spray was fine:
|
|
|
|
|
06-05-2013, 10:01 PM
|
#6 |
|
Drives: 2010 Camaro 2SS/RS Join Date: Feb 2013
Location: Georgia
Posts: 229
|
thanks man it took about 3 hours to do everything. the kit was a great investment..i just hope it lasts a long time...if not, they will be getting powdercoated lol
__________________
2010 2SS/RS- every option possible in 2010
Lighting- LED footwell, grille, trunk, and engine lights done via DIY. LED dome, DRL, and tag lights. Paint- Painted engine cover, steering wheel bezel, speedometer bezel, front bowtie, tail light bezels, wheel center caps. Exterior lights- tinted tail lights and sidemarker lights. Wheels- powdercoated stock RS 20' wheels black Exhaust- Cat-back Dynomax Bullet Exhaust system with bullet muffler delete. Misc- rear blackout kit from Big Worm Graphix, black side Camaro lettering from Emblem Pros, and rear Camaro lettering from Emblem Pros. |
|
|
|
|
|
|
|
 |
|
|
