SLP Extreme Extreme-Duty Rear Half-Shafts - 2010-2012 Camaro V8 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

MarylandSpeed · 09-12-2012, 10:48 AM

Now available at MarylandSpeed!

SLP now offers Extreme-Duty Rear Axle Half Shafts from The Driveshaft Shop for your 2010-2012 V8 Camaro. Designed to handle up to 1,400+ horsepower, these axles feature a full 30-spline using chrome-moly center bars, 108mm (Porsche style) CV's and bolt on chrome-moly inner and outer stubs, these are a direct bolt-on that fit the stock hubs and a must for high-horsepower applications.

The factory Camaro axles are made with different diameter axle bars but, the spline diameter is the same on both sides and the large diameter axle bar tapers down to a spline that is half the diameter. This transition creates a weak point on the axle bar that cannot withstand increased horsepower. These axles are made with 1-1/8" & 1-3/8" diameter bars that are splined on the full diameter of the bar, without being tapered down so drastically and creating a weak point. Not only will these axles handle the horsepower, they use different diameter chrome-moly axle bars on each side which will eliminate wheel hop. Wheel hop at launch can be extremely damaging to the drive-train and makes getting traction very difficult.

Each kit comes complete with all the necessary hardware and detailed installation instructions.

Order on-line or call 443-730-9428!!

09-12-2012, 10:48 AM	#1
MarylandSpeed Account Suspended Drives: 2012 ZL1 & 2010 2SS/RS Join Date: Jul 2009 Location: Maryland Posts: 3,378	SLP Extreme Extreme-Duty Rear Half-Shafts - 2010-2012 Camaro V8 Now available at MarylandSpeed! SLP now offers Extreme-Duty Rear Axle Half Shafts from The Driveshaft Shop for your 2010-2012 V8 Camaro. Designed to handle up to 1,400+ horsepower, these axles feature a full 30-spline using chrome-moly center bars, 108mm (Porsche style) CV's and bolt on chrome-moly inner and outer stubs, these are a direct bolt-on that fit the stock hubs and a must for high-horsepower applications. The factory Camaro axles are made with different diameter axle bars but, the spline diameter is the same on both sides and the large diameter axle bar tapers down to a spline that is half the diameter. This transition creates a weak point on the axle bar that cannot withstand increased horsepower. These axles are made with 1-1/8" & 1-3/8" diameter bars that are splined on the full diameter of the bar, without being tapered down so drastically and creating a weak point. Not only will these axles handle the horsepower, they use different diameter chrome-moly axle bars on each side which will eliminate wheel hop. Wheel hop at launch can be extremely damaging to the drive-train and makes getting traction very difficult. Each kit comes complete with all the necessary hardware and detailed installation instructions. Order on-line or call 443-730-9428!!