Eliminating seat belt buzzer and warning light - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

tys2010camaro · 04-11-2011, 09:33 AM

My 5 point roll cage is on its way from RPMROLLBAR purchased through here on the quantity purchase. KILLER DEAL!!! My 5 point belt harnneses are here. I need to eliminate the seat belt warning light and buzzer as i will not be using the factory seat belts. I see where a couple asked the same question and all they received were OPIONIONS on seat belt safety.

Has anybody eliminated there buzzers and warning lights. THANKS!!

Splitter · 04-11-2011, 09:54 AM

Yeah, someone asked this a year or so back here on this forum and got nuked with "seatbelt safety" lectures from every other member or so. I would say this isn't the place to ask without getting more of those lectures, but obviously you have your 5 PBH and cage on the way, so I doubt you'd be spending money on them without using them.

Either try to do a bit more research and searching if you going to DIY, but otherwise I'd take it down to a private custom shop to have them snip the wire. (I'm lucky that I have a place like that where I live, you may not be as fortunate)

Good luck!

tys2010camaro · 04-11-2011, 10:01 AM

Thanks. I was hoping there was an easy way.

Rogue Leader · 04-11-2011, 10:03 AM

Quote:

Originally Posted by tys2010camaro

Thanks. I was hoping there was an easy way.

Well the easiest way would be to just get a buckle and clip it in and leave it there. Don't know if you want to do that, but it would definitely work.

Nvincent4708 · 04-11-2011, 10:06 AM

There may be a way to spoof the switch inside the buckle end with the orange button. I'm assuming it either leaves the circuit open, or it just closes it. Possible a cut and splice type of job? I know the wire runs down the buckle end towards the floor.

Smoky10 · 04-11-2011, 10:06 AM

I had a 2006 Mustang GT, in the back of the owners manual there was a sequence that you could do buckling and unbucking the seat belt a few times and then you had to turn the ignition on and off a few times. I'm not sure if our cars have that, but it may.

CBRTRX · 04-11-2011, 10:07 AM

There is a small connector on the side of the seat, disconnect and enjoy.

tys2010camaro · 04-11-2011, 10:18 AM

LOTS OF HELP!!! THANKS GUYS!! I APPRECIATE THE HELP!!!! PEOPLE ON MY LAST REQUEST WERE THROWING FITS ABOUT DICONNECTING THE SEAT BELT WARNING SYSTEM. I HAVE A FIVE POINT ROLL CAGE WITH 5 POINT HARNESSES. I DO NOT NEED FACTORY SEAT BELTS.
THANKS AGAIN!!!

Kyle.Gilmour · 04-11-2011, 10:30 AM

Quote:

Originally Posted by CBRTRX

There is a small connector on the side of the seat, disconnect and enjoy.

Quote:

Originally Posted by tys2010camaro

LOTS OF HELP!!! THANKS GUYS!! I APPRECIATE THE HELP!!!! PEOPLE ON MY LAST REQUEST WERE THROWING FITS ABOUT DICONNECTING THE SEAT BELT WARNING SYSTEM. I HAVE A FIVE POINT ROLL CAGE WITH 5 POINT HARNESSES. I DO NOT NEED FACTORY SEAT BELTS.
THANKS AGAIN!!!

is the above statement from CBRTRX true tys2010camaro? Did you try it yet? Try to add some pics of where it is located if you can.

*Camaro_Corvette* · 04-11-2011, 10:40 AM

Finally, A legitimate reason to turn off the seatbelt warning light.

Quote:

Originally Posted by Splitter

Yeah, someone asked this a year or so back here on this forum and got nuked with "seatbelt safety" lectures from every other member or so. I would say this isn't the place to ask without getting more of those lectures, but obviously you have your 5 PBH and cage on the way, so I doubt you'd be spending money on them without using them.

Either try to do a bit more research and searching if you going to DIY, but otherwise I'd take it down to a private custom shop to have them snip the wire. (I'm lucky that I have a place like that where I live, you may not be as fortunate)

Good luck!

Come on now, this is a totally different scenario. I don't see him getting ripped up about this. The other threads were people who just didn't want to wear one in normal day to day driving.

HDRDTD · 04-11-2011, 10:52 AM

Quote:

Originally Posted by tys2010camaro

LOTS OF HELP!!! THANKS GUYS!! I APPRECIATE THE HELP!!!! PEOPLE ON MY LAST REQUEST WERE THROWING FITS ABOUT DICONNECTING THE SEAT BELT WARNING SYSTEM. I HAVE A FIVE POINT ROLL CAGE WITH 5 POINT HARNESSES. I DO NOT NEED FACTORY SEAT BELTS.
THANKS AGAIN!!!

And I'm willing to bet that if you had explained what you were doing, you would have gotten a much better response.
Most people probbably just assumed you just didn't want to be bothered with wearing a seatbelt.
At least now you're getting much better answers.
Good luck.

Captain Awesome · 04-11-2011, 11:04 AM

Quote:

Originally Posted by HDRDTD

And I'm willing to bet that if you had explained what you were doing, you would have gotten a much better response.
Most people probbably just assumed you just didn't want to be bothered with wearing a seatbelt.
At least now you're getting much better answers.
Good luck.

I was wondering if anyone out there had any advice on the best way to drink and drive?

I am having a problem getting the Big Gulp to fit in my cupholder. How do you guys manage to drive your Camaro with a big gulp?

Thanks!

h2oplay · 04-11-2011, 11:15 AM

Quote:

Originally Posted by Captain Awesome

I am having a problem getting the Big Gulp to fit in my cupholder. How do you guys manage to drive your Camaro with a big gulp?

Thanks!

DangerZL1 · 04-12-2011, 12:29 PM

Will a light on the dash appear if the seat belt connector is left unplugged or snipped?

04-11-2011, 09:33 AM	#1
tys2010camaro Drives: 2010 camaro ss Join Date: Jul 2010 Location: Utah Posts: 352	Eliminating seat belt buzzer and warning light My 5 point roll cage is on its way from RPMROLLBAR purchased through here on the quantity purchase. KILLER DEAL!!! My 5 point belt harnneses are here. I need to eliminate the seat belt warning light and buzzer as i will not be using the factory seat belts. I see where a couple asked the same question and all they received were OPIONIONS on seat belt safety. Has anybody eliminated there buzzers and warning lights. THANKS!!

04-11-2011, 10:07 AM	#7
CBRTRX Drives: 2015 CAMARO 1LE Join Date: Oct 2010 Location: Tampa Posts: 195	There is a small connector on the side of the seat, disconnect and enjoy. __________________ 2015 CAMARO 1LE

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Eliminating seat belt buzzer	tys2010camaro	Camaro Motorsports Discussions	4	04-11-2011 12:50 PM

04-11-2011, 09:54 AM	#2
Splitter Account Suspended Drives: '14 RRM 1LT/RS A6 Join Date: Mar 2009 Location: MA Posts: 2,065	Yeah, someone asked this a year or so back here on this forum and got nuked with "seatbelt safety" lectures from every other member or so. I would say this isn't the place to ask without getting more of those lectures, but obviously you have your 5 PBH and cage on the way, so I doubt you'd be spending money on them without using them. Either try to do a bit more research and searching if you going to DIY, but otherwise I'd take it down to a private custom shop to have them snip the wire. (I'm lucky that I have a place like that where I live, you may not be as fortunate) Good luck!

04-11-2011, 10:01 AM	#3
tys2010camaro Drives: 2010 camaro ss Join Date: Jul 2010 Location: Utah Posts: 352	Thanks. I was hoping there was an easy way.

04-11-2011, 10:06 AM	#5
Nvincent4708 Drives: N/A Join Date: Nov 2010 Location: N/A Posts: 25,855 View My Garage	There may be a way to spoof the switch inside the buckle end with the orange button. I'm assuming it either leaves the circuit open, or it just closes it. Possible a cut and splice type of job? I know the wire runs down the buckle end towards the floor.

04-11-2011, 10:06 AM	#6
Smoky10 Drives: 2010 Camaro 2SS Join Date: Jun 2010 Location: Navarre, FL Posts: 745	I had a 2006 Mustang GT, in the back of the owners manual there was a sequence that you could do buckling and unbucking the seat belt a few times and then you had to turn the ignition on and off a few times. I'm not sure if our cars have that, but it may.

04-11-2011, 10:18 AM	#8
tys2010camaro Drives: 2010 camaro ss Join Date: Jul 2010 Location: Utah Posts: 352	LOTS OF HELP!!! THANKS GUYS!! I APPRECIATE THE HELP!!!! PEOPLE ON MY LAST REQUEST WERE THROWING FITS ABOUT DICONNECTING THE SEAT BELT WARNING SYSTEM. I HAVE A FIVE POINT ROLL CAGE WITH 5 POINT HARNESSES. I DO NOT NEED FACTORY SEAT BELTS. THANKS AGAIN!!!

04-12-2011, 12:29 PM	#14
DangerZL1 Drives: 2023 Black ZL1 Auto Join Date: Oct 2009 Location: FEMA Region 4 Posts: 2,935	Will a light on the dash appear if the seat belt connector is left unplugged or snipped?