09-28-2017, 08:08 AM | #1 |
Solo HFC question
I got a set of solo midpipes used on here. Anybody know what size bolts I need to bolt them to stock manifolds? Thanks!
|
|
09-28-2017, 08:27 AM | #2 |
Drives: 2012 ZL1 - #670 Join Date: Jun 2009
Location: Seminole, Fl.
Posts: 8,009
|
Reuse the stock bolts...
__________________
|
09-28-2017, 08:50 AM | #3 |
Aren't they threaded studs? I don't think solo cats are threaded are they?
|
|
09-28-2017, 09:11 AM | #4 |
Drives: 2012 ZL1 - #670 Join Date: Jun 2009
Location: Seminole, Fl.
Posts: 8,009
|
The holes are the same on stock cats and the Solo cats, so if you are bolting up to stock manifolds, just use the nuts and or bolt/nut combo you remove from the stock stuff. The holes in new and old cats are just clearance holes without threads.
__________________
|
09-28-2017, 09:37 AM | #5 |
Ok awesome, thanks for the info!
|
|
09-28-2017, 09:41 AM | #6 |
I dont know if its any different on ls3 from l99 but i couldnt reuse stock hardware on l99, the threaded studs are part of the pipe flange. I went to lowes and bought 3/8 1 1/2 long inch grade 5 bolts with 4 washers and 2 lock washers and 2 nuts and used permatex high temp ultra copper rtv as the gasket, i bought a used set from here and needed to buy all my own hardware, put 1000 miles on the setup so far no leaks no issues whatsoever.
__________________
2012 2ss , long tube headers , summit x pipe ,borla mufflers, vararam intake, vmax ported throttle body rdp motorsports dynosteve tuned, BMR trailing arms and bushings elite engineering catch can. [Ifirst camaro ]2012 LT LFX, nytrex wet system ,GPI dyno tune, Injen longtube intake, Dynomax axle back exhaust, Vmax ported throttle body, elite engineering catch can.
|
|
09-28-2017, 10:56 AM | #7 | |
Account Suspended
Drives: 2012 2SS CAMARO 45th Join Date: Apr 2011
Location: St. Charles, IL
Posts: 18,663
|
Quote:
This works. You can also call Solo and have them send a new gasket set. |
|
09-28-2017, 04:37 PM | #8 |
Tri-County Camaro SWFL
|
The OE cats are a threaded stud. Solo high flow cats used a 13mm or a 15mm bolt, locking washer, nut combo.
__________________
|
|
|
|
|