09-10-2014, 08:36 AM | #1 |
Drives: Black 2010 SS Join Date: Oct 2013
Location: Long Island
Posts: 37
|
Looking to do Nitrous
Ive been wanting to put nitrous on my car for a while now, about a 100-150 shot and also over time heads and cam, was wondering if anyone has had problems with nitrous so far. I know many people I talk to say that the LS motors can handle it but just wanted to see if anyone had problems.
|
09-10-2014, 08:44 PM | #2 |
Speed Freak
Drives: 2013 ZL1 Camaro, 2016 Camaro SS Join Date: Jun 2013
Location: Ardmore, OK
Posts: 2,637
|
I burned one piston while doing a 400 shot. Had to overbore because it scored that cylinder. I ran through 3 bottles hard racing over 1200whp without a glitch. But as you can see I was using a lot of nitrous. As long as afr is correct you should be able to do a 150 shot easy.
__________________
2016 SS -AGP twin Borg Warner 7163 EFR's, LT4 mechanical pump, LT4 injectors, Walbro 255 low side, Castrol SRF. 734whp/759 tq
2013 ZL1 -ADM - 427 LSX 6 bolt, O-ringed block built by LME. Twin PT6466 turbos. RPM custom manual trans, RPS Quad carbon clutch, 9" Hendrix rear diff & axles. ADM/squash fuel system, Ron Davis radiator, Spal fans, AGP air to air, turbo plumbing. LPE oil cooler, rear bushing upgrade, roll bar...etc. rwhp 1400+... 212.5mph, best Texas mile to date. |
09-11-2014, 08:26 AM | #3 |
Drives: 67RS Camaro ,Black 2013 ZL1 Join Date: Jun 2010
Location: Alberta
Posts: 1,408
|
At 100-150 is a decent shot. Better have good fuel.
|
|
|
|
|