08-26-2012, 06:31 PM | #1 |
Banned
Drives: 2010 2SS/RS A6 & 2011 1LT/RS Join Date: Apr 2012
Location: San Diego, CA
Posts: 3,491
|
QTP vs NoWeeds cutouts
Looking at installing some cutouts on my car. I have a full StainlessWorks system with long tubes and high flows. Should I go with QTP or NoWeeds cutouts? I heard the QTP's have solenoid issues but are cheaper than NoWeeds. Also, should the cutouts be installed before or after the high flows?
|
08-26-2012, 06:44 PM | #2 |
Drives: 2015 c7 Join Date: Nov 2009
Location: MI
Posts: 7,462
|
most of the time a well known cutouts do well/fine. get the job done. but no weeds its top of the line stuff. going to be better. personally i went with cutouts it was a lot cheaper. but install was pricy.
install after cats |
08-26-2012, 09:21 PM | #3 |
|
I have both. My vote is NoWeeds.
|
|
|
Thread Tools | |
|
|