Floor jack

[helmincamaro]

Originally Posted by Zabo

Two bolts, a pair of vice grips or channel locks, and patience. Doing both on mine while the wheels are off and it's on the puller. Hilarious too. I just point it out to the local club guys and they're like.. 'Huh.. holy crap you're right!'

How did you not notice why your urethane fender was bulging out like that?



This is why when I change my oil, I just roll it up into the golf course shop, roll the front wheels onto the carrier for our triplexes, and just lift it two feet. I take your 3 ton floor jack and raise you a ? ton Manitowac vehicle lift. No more dicking around with finding lift points for me!

I got a forklift..... so HA!



actually.... I saw my old boss try that with a dump truck . Couldn't lift it up enough so he got a shovel and dug it out from under the tire

[Zabo]

Originally Posted by helmincamaro

I got a forklift..... so HA!

Forklift = swiss army knife on wheels. It slices, dices, and moves an old airplane from one hangar to the scrap heap. I should post pics..