05-20-2014, 10:28 AM | #1 |
Drives: 2014 Blk 2SS/1LE Join Date: Jul 2013
Location: NJ
Posts: 340
|
Elite "Clean Side" Catch Can
Changing out the stock 1LE oil separator for the Elite version cleaned up the look of the engine, they included a long enough hose to route it out of the way - nice touch. If you decide to go this way just note that when trying to put the "can" on be sure to push down on the engine cover for clearance, it makes it a lot easier. Now to the next project... I can see this is fast becoming an addiction!!
|
05-20-2014, 11:10 AM | #2 |
Drives: Chevys at the limit Join Date: Nov 2010
Location: SLC, UT
Posts: 9,621
|
Looks good! Clean install!
Best regards, Tyler 888-308-6007 |
05-20-2014, 11:15 AM | #3 |
Drives: '14 2SS/RS Vert 6M/KTU/NPP/DTA/ARH Join Date: Jan 2014
Location: Indianapolis
Posts: 2,826
|
Lots a lot of hose! The CAI port is higher on the tube allowing a short, direct connection to the CSS. The hose is short enough and stiff enough that it won't sag into the serp.
__________________
Consensus is, by definition, a lack of leadership.
|
05-20-2014, 12:49 PM | #4 |
Drives: 2014 Blk 2SS/1LE Join Date: Jul 2013
Location: NJ
Posts: 340
|
|
05-20-2014, 07:47 PM | #5 |
Drives: 2015 2SS/RS Join Date: Apr 2012
Location: Southeast Louisiana
Posts: 2,112
|
I turned my hose toward the engine. It runs over the top of the water pump and under the cover. Very discrete.
__________________
2015 Camaro 2SS/RS SIM
2016 Jeep Wrangler 2DR Willys Wheeler 1993 C1500 Single Cab Stepside 5.3L LS Swap |
05-21-2014, 07:32 AM | #6 |
Drives: 2014 Blk 2SS/1LE Join Date: Jul 2013
Location: NJ
Posts: 340
|
|
|
|
|
|