10-06-2021, 08:44 AM | #1 |
Drives: 2013 Camaro 1LT Join Date: Jun 2015
Location: Twin Cities, MN
Posts: 329
|
Door Window Control Question
Not sure if any of you would have any insight on this but thought I would ask. So I’m in the process of a drag car build. I need to figure out how to get the windows to work with most of the factory wiring eliminated, as far as when you open the door when the window goes down that little bit. Would prefer to not run the BCM but may have to. I'm not so concerned about getting the power windows to go up-and-down, just the entry and exit thing with the windows.
__________________
Elite catch can & clean side oil separator, Apex Scoop, CAI cold air intake, Vmax ported throttle body, TTT ported intake manifold, JacFab intake manifold spacer, Magnaflow cat back exhaust, Weld RT-S 17x5 f and 17x 9 r wheels, MT 28/6/17 f and M&H 275/50/17 r tires, TTT rear seat delete, Nitrous Outlet plate kit, 125hp jets.
|
|
|