[cengell]

Hello, I was trying to remove my HMI for my 8" display and while under there the was at the time I did not know but it's right under the glove box and it's the passenger side air bag (from what I read after) and so I was carful and removed the 2 bolts and set it to the left that made it much easier to pull down the tray that holds the HMI. As the Car Audio shop did not put back the 2 front bolts but anyways can I just put it back with the 2 bolts as I am waiting for a new HMI unit so I am concerned of course if I get hi at 35 or higher it will go off and it's not secured?

Any suggestions please?

Thanks
Christopher

[keep_hope_alive]

Don't mess around with the airbags when the battery is connected. That is rule #1.

Don't drive around with airbag or SRS systems not connected or not fully secured. That is rule #2.

No exceptions to rules #1 and #2 unless you don't need or don't expect insurance coverage.

[cengell]

Originally Posted by keep_hope_alive

Don't mess around with the airbags when the battery is connected. That is rule #1.

Don't drive around with airbag or SRS systems not connected or not fully secured. That is rule #2.

No exceptions to rules #1 and #2 unless you don't need or don't expect insurance coverage.

Thank you!!!! I will remove battery Neg cable and wait and then attach to under glove box!

Thank you again!
Christopher

[cengell]

Originally Posted by cengell

Thank you!!!! I will remove battery Neg cable and wait and then attach to under glove box!

Thank you again!
Christopher

UPDATE: I was able to put back the Glove Box Air Bag (WITH THE BATTERY NEG WIRE REMOVED) now it's like it was...

Thanks
Christopher