My First Supercharger

[Skoulikimou]

hey guys what catch can do you thing is the best for F/I car ?

[Skoulikimou]

im running 3.8 pulley with 6 psi of boost is that normal ?

[JANNETTYRACING]

Originally Posted by Skoulikimou

im running 3.8 pulley with 6 psi of boost is that normal ?

Yes perfectly normal.

I suggest a ZR-1 Map Sensor, ZR-1 Plugs 3.6 pulley, ZL-1 Fuel pump, and ADM Fuel pump control module for 8.5 PSI boost and 560 RWHP on 93 octane.

Ted.

[LS7 427]

Originally Posted by JANNETTYRACING

I suggest a ZR-1 Map Sensor, ZR-1 Plugs 3.6 pulley, ZL-1 Fuel pump, and ADM Fuel pump control module for 8.5 PSI boost and 560 RWHP on 93 octane.

Ted.

What are you doing on here, don't you take a day off???

[JANNETTYRACING]

Originally Posted by CAMROSS

What are you doing on here, don't you take a day off???

LOL,Feeling A bit under the weather so I was surfing the web to keep my mind busy.

Ted.

[newagemuscle]

Originally Posted by Skoulikimou

In few days i will be installing TVS 2300

i have already LT 1 7/8 , off road pipes , CAI

i will be running on 8 PSI of boost , what dyno numbers should i expect with these mods ?

any recommendations as it is my first supercharged car

thank you all in advance

I also have an LS3. Earlier this year I installed my TVS2300 and at the time I pretty much had the same mods as you... 1 7/8 LT's with hi-flow cats and a roto-fab CAI. Before the blower install my car made 410rwhp. After the install on the same dyno I made 547rwhp. This was with the stock pulley that came with the kit, but a custom tune. I thought it was supposed to be around 6.5 psi with the stock pulley, but could be wrong. Not to mention loss due to long tubes.

[newagemuscle]

Originally Posted by 2SS45th

Hook up the coolant hoses before you put the blower in place, it'll make it 10x easier than trying to fish around below the wiper cowl. I just wish I'd known before I did it.

For sure. I took that advise when I did mine. That had to be a nightmare to do after the fact.

[Piccione Performance]

Originally Posted by newagemuscle

I also have an LS3. Earlier this year I installed my TVS2300 and at the time I pretty much had the same mods as you... 1 7/8 LT's with hi-flow cats and a roto-fab CAI. Before the blower install my car made 410rwhp. After the install on the same dyno I made 547rwhp. This was with the stock pulley that came with the kit, but a custom tune. I thought it was supposed to be around 6.5 psi with the stock pulley, but could be wrong. Not to mention loss due to long tubes.

You are correct, we see between 6.5-7 lbs of boost with the stock pulley.