07-23-2014, 10:30 AM | #1 |
Drives: 2010 Camaro 2SS M6 Join Date: Aug 2011
Location: Jacksonville NC
Posts: 8
|
Wtb rubber manual dust boot for 2010
Looking for undercarriage shift linkage dust cover for bottom of manual trans
Shifter. Pic attached. Thanks |
07-23-2014, 11:46 AM | #2 |
Account Suspended
|
dealer
|
12-03-2014, 02:40 PM | #3 |
Drives: 2010 2SS/RS Join Date: Apr 2011
Location: South Florida
Posts: 109
|
This is old but, this disappeared on my car which I noticed when installing my MGW Shifter. It concerns me because all of my linkage parts are hanging out in the open, that can't be right. I asked my dealer to replace this while doing the recall and they told me that no boot exisits other than the interior boot on the "diagram" they have. So long story short, my dealer has no clue what this is. Does anyone know a part number for this?
__________________
|
12-06-2014, 11:16 AM | #4 |
Drives: 2010 2SS/RS Join Date: Apr 2011
Location: South Florida
Posts: 109
|
Bump
__________________
|
12-06-2014, 12:54 PM | #5 |
Drives: 2010 CGM Camaro 2SS/LS3 Join Date: Oct 2013
Location: Raleigh-Durham
Posts: 1,409
|
Seems like lots of people don't get it installed back correctly and the drive shaft grabs it and rips it off. That's possibly what happened to yours, it's pretty tricky to get it back into the grooves on the shifter body.
Searching around it looks like the boot itself isn't offered as a part and it only comes if you buy a complete shifter assembly.
__________________
2010 2SS
BMR 1" Springs Koni Orange struts/shocks 1LE rear sway bar SRP Racing Pedals Hurst Billet short shifter Square tire/wheel setup Elite Engineering Catch Can Stainless Power longtubes/highflow cats K&N Typhoon CAI RPM Motorsports of Garner, NC dyno tune (421 RWHP) |
|
|
|
|