You are browsing camaro5 
 |
|
10-04-2016, 05:05 PM
|
#1 |
 Drives: 2013SS IOM LS3 Join Date: Mar 2013
Location: Houston, TX
Posts: 168
|
Can someone point me to the DIY I saw to replace the foglight bulb
I searched, but I may not be hitting the right keywords, I swear I saw a DIY on this. I dont have to put the car on stands as I recall, I can go through the wheel well (after undoing the fender bolts?) Need to replace by LED foglamp bulbs with new ones...
__________________
 CamaroSS - Daily 476whp@6300rpm, 2001 Dodge Viper GTS - Toy (sold) |
|
|
|
10-04-2016, 05:15 PM
|
#2 |
         
Drives: 2011 1LT/RS A6 RJT SuperCharged Join Date: Mar 2011
Location: 87114
Posts: 3,503
|
It's honestly not that hard to do.
-Turn wheel to the opposite side of the bulb you are changing. -Remove the screws holding the front of the wheel well. -Peel back the wheel well -Reach in and undo the bulb from the housing (a flashlight helps a lot to see) -Separate the bulb from the harness. -Attach new bulb and reverse the process.
__________________
Power is worthless without control. The 2nd protects the 1st.
BMR sub frame brace, BMR tunnel brace, LSR sways, LSR CM ca & tl, Sphon ExD el, GM tower brace, Megan EZ Streets, Goodridge Stainless Steel Braided brake lines, PowerStop D/S rotors & pads, Doug Thorty Ceramic Shorties, Magnaflow x-pipe, MRT V2.0, KICKER PowerStage sub & amp, Infinity speakers & tweeters, Viteese Throttle Controller, Viteese Paddle Shifters, ACS T2 Splitter, ACS T2 Ports/Quad LED lights, VDI kit, Havoc diffuser, IPF ECU/TRANS tuned, IPF/KPE Supercharged. 364RWHP/297RWTQ |
|
|
|
|
10-14-2016, 12:22 PM
|
#3 |
|
Drives: 2013SS IOM LS3 Join Date: Mar 2013
Location: Houston, TX
Posts: 168
|
thanks Dizzy, much appreciated!
__________________
CamaroSS - Daily 476whp@6300rpm, 2001 Dodge Viper GTS - Toy (sold) |
|
|
|
|
|
|
|
 |
|
|
