06-15-2017, 09:34 AM | #15 |
Resident nomad
Drives: 2014 Summit White 1SS/1LE Join Date: Nov 2015
Location: Gilbert, AZ
Posts: 1,765
|
Sometimes the answers to these questions seems self-evident OP.......And $600 for the dealer to replace the weatherstripping and battery?! WTF?
__________________
Sold:
2007 Z06 2002 Viper GTS/ACR 2003 Z06 1965 FFR Cobra 2012 Nissan 370Z ADM LSA Stage II, Roto-Fab CAI, Kooks LTH/HFC's, Phastek CC, ported TB, Mishimoto radiator and oil cooler, BC Racing ER Series CO's, JPSS 32mm Black Magic rear bar, JPSS front inserts, R1 Concepts Premier slotted rotors/Goodrich SS lines, Schroth ASM harness, MGW flatstick, Brey-Krause HB, Tuned by NicD, at Cordes Performance Racing. |
06-15-2017, 09:51 AM | #16 |
Drives: White 2011 RS with black stripes Join Date: Jan 2017
Location: N. Florida
Posts: 9
|
It's down by the bumper. The only reason I wrote was to see if anyone had this problem before, and to see if anyone suggested a product to maybe patch it like a 3m product, instead of spending $70 on a new seal. Thanks!
|
06-15-2017, 11:20 AM | #17 |
|
You should sell the car now if you can't afford 67 dollars for the correct part instead of halfassing it .
__________________
Mods, K&N CAI ,VTC , GM Perf Axleback Exhaust, Elite Eng CC and CSS, GM Strut Tower Brace,Carbon Fiber Anvil Spoiler,ASC T5 Splitter,Gen5diy Foglight kit.
|
06-15-2017, 11:49 AM | #18 | |
Drives: 2014 2SS/RS Join Date: Dec 2014
Location: Raleigh, NC
Posts: 1,053
|
Quote:
Available in Clear and Black from many companies. Should clean the surface good before applying (e.g. 70% rubbing alcohol), and let fully evaporate. Best to let have the glue set up for a few hours before closing trunk lid and/or can cover metal trunk lid area with saran wrap until it is dried. Note "For Use On:" at bottom of picture. Do NOT use the type that stays semi-liquid which is used to fix windshield gasket leaks.
__________________
2014 2SS/RS, Z28 CAI and High Wing Spoiler, ZL1 5.1:1 Ratio Short-Throw Shifter, ZL1 Pedals, ZL1 splash guards, NPP Dual-mode quad tip exhaust, Z28 strut tower brace, Camaro LED Cup-holders with footwell Lighting option, Leather visors, and Leather E-brake boot. Chevy dealer sponsored 67 retro SS nose stripe package.
Last edited by ron123; 06-15-2017 at 12:10 PM. |
|
06-15-2017, 11:57 AM | #19 |
Drives: 2017 Mosaic Bk ZL1 M6 Join Date: Jul 2009
Location: South of Raleigh, NC
Posts: 9,477
|
No need to sugar coat it
__________________
|
06-15-2017, 01:53 PM | #20 |
I like teeth.
Drives: #198 Join Date: Oct 2009
Location: Ft. Lauderdale, Florida
Posts: 4,817
|
lot of the wires went bad too due to the mini flood in there. Lots to be replaced
__________________
.
Please check out my youtube detailing channel: http://www.youtube.com/user/roshan517 "When you want to succeed as bad as you want to breathe, then you will be successful." |
06-15-2017, 03:29 PM | #21 |
Just an average Dude
Drives: 2015 1LT Grey w/Orange Rally Stripe Join Date: Mar 2016
Location: Hickory, NC
Posts: 391
|
I've used black RTV sealant similar to ron123's post in a pinch until I could get new seals on cars in the past.
__________________
So far I like my car the way it came from the factory.
|
06-15-2017, 04:02 PM | #22 |
Drives: White 2011 RS with black stripes Join Date: Jan 2017
Location: N. Florida
Posts: 9
|
|
06-15-2017, 05:51 PM | #23 |
Drives: 2013 1SS L99 Join Date: Dec 2015
Location: Brandon,MS
Posts: 60
|
Leak
Look for two grommets one on either side of the trunk opening near the bottom of back glass. Then look inside your trunk and find the plastic tubes that fit into the grommets. I used slightly tight hose clamps to fix my leak. If you need pictures I can post some.
__________________
2013 1SS/RS L99-GPI VVT SS1 - TSP 1 7/8 headers with Borla Touring exhaust - ESS Tuning YSI V7 - Fore Innovations Dual pump fuel system - 1" BMR lowering springs - BMR toe rods and trailing arms - Prothane rear cradle bushings - Yank 3400 Stall -
|
06-15-2017, 05:58 PM | #24 |
Drives: 2013 1SS L99 Join Date: Dec 2015
Location: Brandon,MS
Posts: 60
|
leak
Pics of sunroof drains
__________________
2013 1SS/RS L99-GPI VVT SS1 - TSP 1 7/8 headers with Borla Touring exhaust - ESS Tuning YSI V7 - Fore Innovations Dual pump fuel system - 1" BMR lowering springs - BMR toe rods and trailing arms - Prothane rear cradle bushings - Yank 3400 Stall -
|
|
|
|
|