07-03-2012, 02:19 PM | #155 |
Drives: Soon to buy 2012 Ashen Gray 2LT RS Join Date: Jul 2012
Location: Texas
Posts: 2
|
Will this work?
http://emblempros.com/inc/sdetail/3436/3337
Is this a fairly simple mod? I've read through the entire thread and see that many of you had success. Anyone's led burn out yet? Also didn't find much info on the footwell floorboard lighting, where the light is placed or where the wiring is tapped into. Thanks. |
07-09-2012, 06:28 PM | #156 | |
|
Quote:
|
|
07-16-2012, 08:27 PM | #157 |
Drives: ELLE-1 Join Date: Jul 2011
Location: Farmington ,mo
Posts: 1,175
|
book
__________________
|
07-20-2012, 02:28 PM | #158 | ||
LED god
Drives: 2010 Inferno Orange Camaro SS/RS Join Date: Oct 2010
Location: Las Vegas, NV
Posts: 537
|
LED cupholder and footwell.
Love what all you guys have done!!! The lighting under the cover plate is a cool idea! Just wanted to share what I did. I have a RGB color changing and moving dream color ABL mod that I tied into so the cup holders mirrored that lighting effect. Each has one three LED strip.
I also did a full RGB interior light set up. 11 strips total, 2 in dome, footwells front and rear, front of drivers seat, sills and entire rear window. Dome and rear window are on a switch to shut off. Controller does all colors, fades, flashes and any hue of any color. Comes on with switch or when u open doors. Fades in and out and remembers color. Check out the vid of my cupholder lights!!! Vid of interior lights, sorry little dark.
__________________
|
||
07-30-2012, 02:39 PM | #159 |
Drives: Summit White 2012 1LT/RS Join Date: Dec 2010
Location: California
Posts: 191
|
looks awesome...this is my next mod.
Which t-taps do I get. What gauge.
__________________
2012 Summit White 1LT/RS
Cold Air Inductions CAI, VMaxx ported throttle body, RX catch can, Led Interior Lights, Led License plate lights, Hood Spears, Blacked Out Rear Trunk panel, Gills, Blacked Out Front Fascia, and Bow tie |
07-30-2012, 03:31 PM | #160 |
LED god
Drives: 2010 Inferno Orange Camaro SS/RS Join Date: Oct 2010
Location: Las Vegas, NV
Posts: 537
|
If using shifter led tiny like 16-18 gauge. If off the 12 outlet bigger like 8-10 gauge area. Both good choices so its always on vs ambient lighting only. Member u need a led ok with 12v, like factory with the resistors already attached.
__________________
|
07-30-2012, 03:49 PM | #161 |
Drives: Summit White 2012 1LT/RS Join Date: Dec 2010
Location: California
Posts: 191
|
What about if I plan on going off the traction control. Or is it better to go off the shifter lighting
__________________
2012 Summit White 1LT/RS
Cold Air Inductions CAI, VMaxx ported throttle body, RX catch can, Led Interior Lights, Led License plate lights, Hood Spears, Blacked Out Rear Trunk panel, Gills, Blacked Out Front Fascia, and Bow tie |
07-30-2012, 05:01 PM | #162 |
LED god
Drives: 2010 Inferno Orange Camaro SS/RS Join Date: Oct 2010
Location: Las Vegas, NV
Posts: 537
|
Either will have plenty of amps for two tiny leds. TC may only have power when lights r on though. I think shifter always does when car is on. Both r small wire. U would have to find which on TC is 12V power though.
__________________
|
07-30-2012, 05:23 PM | #163 |
Drives: 2016 SS w/2SS A8 Blue Velvet Join Date: Dec 2009
Location: 39.793153,-86.238223
Posts: 3,678
|
I used the Traction Control wiring. Yellow for power and the black for the ground. Nuff Sed!
__________________
Never grow up, it's a trap!
|
07-30-2012, 05:35 PM | #164 |
Drives: Summit White 2012 1LT/RS Join Date: Dec 2010
Location: California
Posts: 191
|
I'm looking for what gauge t-tap to get to wire into the TC wiring.
__________________
2012 Summit White 1LT/RS
Cold Air Inductions CAI, VMaxx ported throttle body, RX catch can, Led Interior Lights, Led License plate lights, Hood Spears, Blacked Out Rear Trunk panel, Gills, Blacked Out Front Fascia, and Bow tie |
08-09-2012, 02:41 PM | #165 |
Drives: Currently 2016-2SS, Future ZL1/Z28 Join Date: Jul 2010
Location: Kansas
Posts: 978
|
work on this because I wanted to give a better harmony with the doors abl
|
08-09-2012, 02:47 PM | #166 |
Drives: Currently 2016-2SS, Future ZL1/Z28 Join Date: Jul 2010
Location: Kansas
Posts: 978
|
close up
|
08-09-2012, 07:33 PM | #167 |
Love the fact this thread is still going strong!!! Looks great guys!!
|
|
08-11-2012, 07:15 AM | #168 |
Drives: 2012 IOM 2LT RS - Traded In Join Date: Nov 2011
Location: Port Richey, Florida
Posts: 367
|
Any try the Orange for the IOM? Debating on Red or Orange.
Also found more colors for the plates!! Black - http://www.phastekperformance.com/20...113-pl-blk.htm Orange - http://www.phastekperformance.com/20...-113-pl-or.htm Satin - http://www.phastekperformance.com/20...113-pl-sat.htm Polished - http://www.phastekperformance.com/20...113-pl-pol.htm Was thinking getting myself the Orange but doesnt seem to be same IOM and I think it might be to much Orange for me haha. Going with the black!
__________________
TRADED IN - 2012 2LT RS - VMAX Throttle Body - MRT V1 - CAI - Trifecta Tune - Matching Interior Lightning (Footwells and Dome) - Sequential Taillights - Blacked out Front n Back Bowties - 228VX Train Horn Traded for 2011 Corvette |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installed full dash and doors ABL, foot lighting with custom cup holder switch plate! | CamaroC-17 | Camaro Photos | Spyshots | Video | Media Gallery | 23 | 02-06-2013 09:45 PM |
DIY add light to inside door handle | overhaulengines | Camaro DIY & HOW-TO instructions & discussions | 32 | 07-21-2011 09:58 PM |
DIY custom ABL | BlueSteele | Camaro DIY & HOW-TO instructions & discussions | 5 | 02-07-2011 01:05 AM |
ABL lighting and Footwell Light Install? | JProberts | USA - Mid-Atlantic | 3 | 02-25-2010 10:17 PM |