03-03-2013, 11:22 AM | #15 |
I purchased an inline fuse holder for $2.00 and used the power and ground wires
at the garage door remote in the overhead console. Worked perfect> |
|
03-06-2013, 01:23 PM | #16 |
HT5 EastSide
|
My passport is powered by a cig lighter. would I just cut and strip that wire and connect longer wires so that it could reach the fuse box? or what?
|
10-15-2013, 11:47 PM | #17 |
Drives: 2013 1lt rally yellow Join Date: Dec 2012
Location: Long Beach
Posts: 21
|
Does anyone have a picture of where the gap is from the inside of the fuse box to the corner to fish the wire? I hardwired my detector but I can still see my wire running from the fuse box to the corner.
|
10-17-2013, 06:12 PM | #18 |
The gritos pollo!!!
|
It's had to see but it's right on top of the sound deadener. You can see part of the white coat hanger. If you fish it from the dash about an inch from the pillar you should have no problem but you can't pull it around the pillar, tape it to a hanger or piece of wire and pull it though.
__________________
______
If you don't stop how can they give you a ticket?-The Big Tuna___ '12 1Ls Camaro; Slp loud mouth I|maganflow x-pipe|Injen long ram intake|brembo brake upgrade| russell s.s. lines|2LT polished 19's|billet 5mm spacers|tinted tail lights&markers|pdmi|billet c. can| '13 Avenger R/T '77 T/A 6.6;, draining my wallet. |
10-17-2013, 08:17 PM | #19 |
Drives: 2013 1lt rally yellow Join Date: Dec 2012
Location: Long Beach
Posts: 21
|
thanks!! I will give it another shot.
|
10-26-2013, 10:01 AM | #20 |
Drives: 2011 White RS Vert Join Date: Aug 2013
Location: Vancouver Island BC
Posts: 33
|
Thats a nice clean way to do the install....exactly the way I'm going to install my Belltronic Pro 300. The nice thing about this detector is that wiring uses a black Rj-11 standard phone cable that plugs directly into the detector this makes for an even cleaner install. I have the same wiring in my work truck allowing for easy plug and go on either vehicle. Personally I seem to get a better rear radar detection if the unit is mounted in a higher location opposed to the lower on the dash mount.
|
|
|
|
|