10-11-2014, 08:14 AM | #1 |
Drives: 2011 2SS/RS L99 RJT Convertible Join Date: Sep 2014
Location: NH
Posts: 306
|
Pre-lift for Floor Jack
I don't have a low profile floor jack and couldn't get the one I have onto the front cross member, so I pulled out my old homemade ramps, which raises the car just high enough to slide a standard floor jack under it.
I made these for a previous lowered car because I couldn't use standard ramps without running the front fascia into the ramps before the car tires actually engage the ramp. The secret is to have just enough run on each step of the ramp so at any given time your front fascia only needs to clear one and half inches. Oh, just make sure your can count to three. You don't want to drive over the forth step.
__________________
Flowmaster Force II Axle back, Kooks LT's and Highflow Cats, Oracle Side Makers, BC Coilovers, E-Force Supercharger, Rotofab Intake, HexVents, ACS T4 Splitter/Rockers/Wind Deflectors, Aeroforce dual pod, Autometer boost/WB analog gauges, MRR M228 20x10 20x11 Nitto Invo 275/315's, CDC Sport Bar, Tuned by Slowhawk Performance.
|
10-11-2014, 08:18 AM | #2 |
Drives: SUMMIT WHITE 2SS/RS CAMARO Join Date: Feb 2008
Location: 2018: Lakewood Ranch, Fl.
Posts: 8,112
|
Nice- I made my first set in high school wood shop years ago.
__________________
|
|
|
|
|