Anyone else have a KD Innovations cooler?

[OVERPAR73]

I recently purchased a KD Innovations cooler from a member for my 2013 ZL1 convertible and now find out it won't fit because of the extra bracing on the front of the stock radiator and this new cooler is over 3 inches thick. Does anyone else have this cooler installed on their convertible and how did you go about installing it and what did you do with the two braces in front of the radiator? I'm looking for any help someone can provide me with the installation of this cooler. Please HELP, thanks.

Bill
Overpar73

[AMMUSCLE]

Originally Posted by OVERPAR73

I recently purchased a KD Innovations cooler from a member for my 2013 ZL1 convertible and now find out it won't fit because of the extra bracing on the front of the stock radiator and this new cooler is over 3 inches thick. Does anyone else have this cooler installed on their convertible and how did you go about installing it and what did you do with the two braces in front of the radiator? I'm looking for any help someone can provide me with the installation of this cooler. Please HELP, thanks.

Bill
Overpar73

No worries.
Just take off the front brace over the front cooler you will be ok and do not need it. This is the brace that is a v shape.
I have the DP3 and its even larger.
If you follow the post on this the install I edited it has all the install instructions including the plastic shroud cutting and trimming along with relocating the heat sensor in the shroud.
I will try and find it and post it for you when I get a chance.
try this link
https://www.lingenfelter.com/sites/l...ZL1%20v1.1.pdf

[JFWJR179]

I have a KD innovations heat exchanger in my 2013 vert
installed without any issues by Lethal Racing LLC