01-29-2014, 10:57 PM | #1 |
Drives: 2010 2SS, Black w/ Black Stripes Join Date: Jul 2013
Location: Portland
Posts: 23
|
DRL Replacement
I'm looking into replacing my factory DRL lights because it bugs me how cheap they look when I know how my car looks when the halos or HIDs are on. I found the AAC option, but those are $100 which seems like an awful lot to spend on a couple bulbs. Also, there seems to be an option for halo DRLs which is only $20 more if I'm reading it correctly. I could also go with some cheaper ones off amazon, but I'm equally concerned about those for obvious reasons. So my question is basically is this upgrade worth the $100? Or has someone gone the cheapskate route and worked out just fine?
Another issue I'm a little torn on is getting the harness to make the halos the DRLs and have the DRLs come on with the headlights. On one hand, I really wish the halos were the DRLs but I also like the look of when only the headlights are on at night. |
01-29-2014, 11:11 PM | #2 |
Drives: 2013 camaro SS/RS 2012 camaro RS Join Date: Mar 2013
Location: Crossville TN
Posts: 377
|
|
01-30-2014, 08:05 AM | #3 |
I bought these plus the harness. I really like the way they look now.
http://www.phastekperformance.com/20...s-led-p13w.htm |
|
01-30-2014, 08:09 AM | #4 |
Drives: 2011 Camaro LS Join Date: Jan 2012
Location: Euless, Texas
Posts: 527
|
www.gen5diy.com Their prices are very reasonable.
__________________
|
01-30-2014, 08:29 AM | #5 |
Todd
|
listen here, go on ebay and get a pair for 20$ and thank me later. mine look awesome and almost match the factory hid headlights (very slightly bluer) .
|
01-30-2014, 11:40 AM | #6 |
Drives: 2010 camaro 2SS RS LS3 Join Date: Nov 2013
Location: waterbury
Posts: 134
|
I replaced my factory light housings with some non rs ones and put in some 5000k hids from ebay...so far so good. I also got the harness to make them work with the halos. I am more then happy with it all.
__________________
2010 Camaro SS LS3 Kraftwerks Supercharger 594rwhp 9.5 psi Dynatech 1.875" Headers, Dynatech Highflow Cats, 3" Flowmaster, JRE Tune, More to come!!!
1970 GTO Butler built 474 stroker, Pump GAS 1987 Monte SS Healthy sbc 5 speed |
01-30-2014, 05:00 PM | #7 |
Drives: 2013 RS Join Date: Jan 2014
Location: Louisiana
Posts: 18
|
|
01-31-2014, 10:20 AM | #8 |
Todd
|
they removed the listing i bought from but these are the exact same thing http://www.ebay.com/itm/HID-equivale...a25716&vxp=mtr but if i were buying a pair all over again i would get these- they look awesome http://www.ebay.com/itm/P13W-12277-W...3bbabd&vxp=mtr |
01-31-2014, 09:49 PM | #9 | |
|
Quote:
These ones will fit for 2010 SS DRLs?? same boat I hate the yellow look of them!
__________________
Cold Air Inductions CAI Stainless Power LT's with HFC's Flowmaster American Thunder Cat Back APEX Scoop and WW Relocation Kit VMAX Ported Throttle Body Custom Dyno Tune Pfadt 1.25" Lowering Springs ZL1 Rims on 275 front 315 Rear custome underlay vinyl wrap Anvil Spoiler heritage grill APR Front Splitter Custom Emblempros emblems ZL1 Side Skirts 416.5 whp 410 torque (CURRENTLY) Up Next: BTR Stage 3 Cam and supporting mods (in garage now)
|
|
02-02-2014, 09:21 PM | #10 |
Todd
|
|
02-03-2014, 02:20 AM | #11 |
|
__________________
Cold Air Inductions CAI Stainless Power LT's with HFC's Flowmaster American Thunder Cat Back APEX Scoop and WW Relocation Kit VMAX Ported Throttle Body Custom Dyno Tune Pfadt 1.25" Lowering Springs ZL1 Rims on 275 front 315 Rear custome underlay vinyl wrap Anvil Spoiler heritage grill APR Front Splitter Custom Emblempros emblems ZL1 Side Skirts 416.5 whp 410 torque (CURRENTLY) Up Next: BTR Stage 3 Cam and supporting mods (in garage now)
|
02-03-2014, 07:34 AM | #12 |
Wicked ZL1
|
The only problem with buying them from ebay is you can not exchange them if and when they fail. AAC and Gen5Dyi both have lifetime warranties. I have had this bulbs since 2009, and have replaced them a few times with no issues from either company.
__________________
2017 Hyper Blue Metallic ZL1 A10/CF Hood Insert/PDR/NAV MODS: Rotofab CAI/V-MAX CNC Ported Throttle Body/Clear Bra/LED Reverse Light/Rock Guards/Lift Pads/Darkened Tail Lights/Ghost-Tinted LED Side Markers/Darkened 3rd Brake Light
|
02-03-2014, 02:04 PM | #13 |
Todd
|
I've had my bulbs for a year now, ebay wont fail. you'll be fine.
|
02-03-2014, 03:12 PM | #14 | |
Wicked ZL1
|
Quote:
http://www.gen5diy.com/psx26w-11-wat...20watt%206000k
__________________
2017 Hyper Blue Metallic ZL1 A10/CF Hood Insert/PDR/NAV MODS: Rotofab CAI/V-MAX CNC Ported Throttle Body/Clear Bra/LED Reverse Light/Rock Guards/Lift Pads/Darkened Tail Lights/Ghost-Tinted LED Side Markers/Darkened 3rd Brake Light
|
|
|
|
|
|