10-03-2011, 12:24 AM | #1 |
OFF THE CHAIN
|
L99 Cam Install Washington State?
Need advice on a Cam install and full Dyno tune? Is there anyone out there who recommends or has some names of reputable folks who do the highest quality of work like a tune and Cam install in Washington State?
I HAVE A 2010 RS/1SS - A6 |
10-03-2011, 02:35 AM | #2 |
Slow Turtle
|
Where are you located?
|
10-03-2011, 07:24 PM | #3 |
OFF THE CHAIN
|
I will be located in Oak Harbor Washington, about 110 miles North of Seattle
|
10-03-2011, 07:33 PM | #4 |
Account Suspended
Drives: 99 Camaro SS, 79 z28, 70 GTX Join Date: Oct 2009
Location: ST Helens, OR
Posts: 1,759
|
Well, you have Speed Secrets up there in Snohomish, Ellis is a good guy ..
If you want to travel you have Tom at Wongs Performance down in Vancouver.. Either of those two will take care of you, tell them Chris at CC performance told you to call Snohomish is certainly closer but its still going to be a drive for you |
10-03-2011, 09:42 PM | #5 |
OFF THE CHAIN
|
Well thanks Chris, all these mods sitting in my Arctic entry and no one to put them on in Washington, you made it easier for sure, thanks again! CHEERS!
|
10-04-2011, 08:17 AM | #6 |
Drives: 2011 Camaro 2SS/RS (Black) L99 Join Date: Aug 2010
Location: Pilot Point, Texas
Posts: 2,185
|
Lg Motorsports G6X3! Top-of-the-line!
|
10-04-2011, 09:57 AM | #7 |
OFF THE CHAIN
|
|
10-04-2011, 10:14 AM | #8 |
Account Suspended
Drives: 99 Camaro SS, 79 z28, 70 GTX Join Date: Oct 2009
Location: ST Helens, OR
Posts: 1,759
|
Thats was a drive-by cam suggestion..LOL
|
10-04-2011, 02:29 PM | #9 |
Slow Turtle
|
+1 for speed secrets in snohomish
|
10-05-2011, 03:44 PM | #10 |
OFF THE CHAIN
|
Actually price is not a factor, i just want a L99 Cam swap, but i do want new lifters in there, also LT Headers ARH and American Racing Flowmaster set from there, i also need my maggie installed. Hopefully Wongs or Ellis at SPeed Secrets can handle this all for me?
|
10-05-2011, 03:46 PM | #11 |
OFF THE CHAIN
|
Also i am moving out of Alaska, Car ships tommorow morning from Fairbanks Alaska to Anchorage Alaska, then heads down on Monday's Barge to Seattle, will be available when i get off the plane in Sea-Tac after 2:00 pm Monday October 17th for pickup.
|
10-05-2011, 05:25 PM | #12 |
Camaro Owner Since 1987
Drives: 2011 2SS/RS L99 RJT Join Date: Jun 2006
Location: Lawrenceville, GA
Posts: 2,185
|
Good luck with the install.
Bill
__________________
2011 Camaro 2SS/RS L99 RJT
CAI, Inc. Cold Air Induction;ADM Scoop Rx Catch Can;Rx Breather;Roto-Fab Washer Container VMax Ported RJT Throttle Body XSPower Headers and XSPower 3" Exhaust System Elite Engineering Tunnel Brace, Gorilla Wheel Lock System; Bear Rotors, Hawk HPS Tinted Windows 35%;EFILive Tune |
10-05-2011, 10:23 PM | #13 |
OFF THE CHAIN
|
Thanks Bill!
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My Camaro went home to Oshawa to die...... | Huggerorange73 | 5th Gen Camaro SS LS LT General Discussions | 753 | 08-30-2011 02:40 PM |
L99 Texas Speed VVT Cam/Head install | tvwilkes | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 33 | 10-13-2010 05:48 PM |
L99: Cam or Forced Induction? | AdamCzap | Forced Induction - V8 | 7 | 08-25-2010 08:09 AM |
Step by step instructions cam install LS1 | Onetime | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 4 | 06-04-2010 10:14 AM |
L99 engine specifications | Tran | Wiki | 0 | 10-19-2008 11:40 AM |